11.07.2015 Views

Multisport 270 Owner's Manual - Aquaglide

Multisport 270 Owner's Manual - Aquaglide

Multisport 270 Owner's Manual - Aquaglide

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

IX. Storage1. Disassemble the <strong>Multisport</strong> following the assembly steps in reverse.NOTE: it is not necessary to remove the sailing harness from the hull, orto remove the main sheet/ uphaul strap from the boom. These items canbe kept in place, making the next assembly easier.7. Folding the hull. Onceall the air is removed fromthe hull, fold the hull intothirds, lengthwise. Photo 7shows the first of two folds.7BackFront2. Before storing, make sure all parts are clean and completely dry.Once stored, any moisture in the product can encourage mildew, whichcan permanently stain, and ultimately damage, the product.3. Remove the air from the hull by unscrewing each valve cap andreleasing each valve flap. For deflation, it is best to reach through thevalve hole and pull the flap through the hole with one finger. This allowsthe air to escape freely without becoming trapped in the bladder. Fortight packing, remove all air from the hull using the DEFLATE port in thefoot pump.8. Next, fold the hull in halffrom front to back as shownin photo 8.84 Store the product out of direct sunlight and protected from the environmentin a clean, dry location. Do not store in a damp location. Donot store at temperatures below freezing, as damage to the product mayoccur.5. Once disassembled, follow the steps below to pack the <strong>Multisport</strong><strong>270</strong> in the roller travel bag for storage or transport.9. Packing the bag. Beginby packing the rudder, keels,pump and sailing harness (ifdetached).96. Rolling the sail. The <strong>Multisport</strong> sail should be rolled up for storage.Fold the top of the sail over the top batten and begin to roll the sailfrom this point as shown in photo 6A below. Continue as shown in photo6B until the sail is completely rolled. Slip the rolled sail into the sail bagfor storage.6-A 6-B10. Next, place the foldedhull in the bag.1011. Last, place the mast,boom and sail on top of thehull. The mast and sail needto be placed at a diagonalangle relative to the bag inorder to fit properly. Carefullyzip the bag closed and storein a warm, dry location.11for more info go to:26<strong>Aquaglide</strong>, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966www.<strong>Aquaglide</strong>.net

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!