Multisport 270 Owner's Manual - Aquaglide

E-7IV. Assembly - WindsurferWhen setting the Multisport 270 up for windsurfing, follow the assemblyinstructions for sailboat as noted below, with the followingexceptions:A. Preparing the Hull1. Same as sailboat assembly beginning on page 6.B. Preparing the Rig1. Same as sailboat assembly begining on page 6, except:7. Connect the tiller handle at the upper hole in the rudder shaft usingthe remaining tethered clevis pin as shown in photo E7. The tiller handleshould connect at the back and face toward the front of the hull.B-28. Finally, secure the clevis pin with the remaining tethered D-ring.E-8F. Assembly Complete - Now What? B-31. This completes the Multisport 270 sailboat assembly. Before takingoff for your first sail, be sure to read and understand the information onOperation of your new boat. Skip to page 24 for Operation.2. IMPORTANT: Before using the product, be sure to read andunderstand the Warnings on page 4-5.3. IMPORTANT: When moving the Multisport 270, always lift andset it down. DO NOT DRAG, as this can damage the product beforeyou get started. It is helpful to have an assitant available for launchingand moving the craft while on land.2. Do not follow steps B16 through B19 for attaching the main sheetstrap to the back of the boom. Instead, the main sheet/ uphaul strap istied to the rope loop at the front of the boom to be used as an uphaul.3. Thread the rope at the top portion of the uphaul strap through thewhite rope loop at the front of the boom. Take an additional turn aroundthe white loop as shown in photo B3.for more info go to:18Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966www.Aquaglide.net