Multisport 270 Owner's Manual - Aquaglide

D-2FrontD-4Front2. Connect the mast base to the mast step using the two integratedstraps and buckles. Take each strap through the corresponding maststep connector and secure using the corresponding buckle. Once connected,cinch both straps firmly.3. Next, you are ready to attach the sailing rig. It may be helpful to havean assitant available to steady the rig during this process. Lift the sailingrig into position with the mast over the mast base and toward the frontof the hull. Slide the mast over the upper part of the mast base until it iscompletely seated.D-34. Secure the rig to the mast base using the strap at the foot of the sail.Lead the strap around the catchment on the upper part of the mast basethen back to the buckle at the foot of the sail as show in photo D4 onthe following page. Tighten by pulling down on the sail while cinchingfirmly on the sail strap. Repeat this several times until the sail can go nofarther.5. Attach the lower partof the uphaul strap to thesame catchment on themast base. Lead the freeend of the webbing straparound the mast andcatchment, then back up tothe buckle part way up theuphaul strap. Secure theend of the webbing with thebuckle. The end result isshown in photo D5.D-5Main Sheet/Uphaul StrapFrontfor more info go to:20Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966www.Aquaglide.net