KENWOOD TH-78A 144/440 MHz Dual Bander - The Repeater ...

3) Use the keypad to select any desired memory channel number (0-49). For example, use a two digit number,such as 02 for channel 2, or 15 for cannel 15, to enter data in memory.4) Press the MR key.5) The memory channel number will turn off, indicating that the receiver data has been properly stored.6) Use the numeric keys to enter the desired transmit frequency.7) Press the M key. The memory channel indicator will flash.8) Press and hold the PTT switch and then press the MR key.9) The TX frequency is set. The system returns to its previous state.NoteYou will hear an error sound if you attempt to recall a memory when nothing is stored in that memory.Confirming the Contents of the Split ChanneI1) Press the MR key. The programmed receiver frequency appears on the display with " + "and "-" offset directionindicators showing that this channel has an odd split entered.2) Press the F key, then press the SHIFT/REV key, or just the PTT switch, to check the transmit frequency. Thetransmit frequency will appear on the display.7 Entering The Call Channel Frequency1) Use the numeric keypad to select the desired receiver frequency, tone and other information.2) Press the M key, then press the CALL key within 10 seconds. You have now entered the call channelfrequencyIf entering an odd split channel, continue with steps 3 to 6.3) Select the desired call channel transmit frequency.4) Press the M key.5) Press and hold the PTT switch and press the CALL key.6) Release the PTT switch.Page 17