Mitutoyo1001 Catalog.pdf - JW Donchin CO.

Combination Square SetSERIES 180Technical DataSquare head: Used to set the rule at 90 degrees or 45degrees to an edge of a workpiece.Center head: Used to locate centers of round workpiecesProtractor head: Used to set the rule at a desired angle toan edge of a workpiece. Also used formeasuring angles.FEATURES• Three measuring heads are attached tothe stainless steel rule (blade), allowingversatile measurements on various types ofworkpieces.• The measuring heads are hardened.• Economy sets not including a protractorhead are also available.SPECIFICATIONSInch / MetricBlades onlyOrder No. Length Graduations Accuracy (length)180-406U 4” 8, 16, 32,64ths (4R)180-407U 4” 32, 64, 50,100ths (16R)180-408U 4” x 100mm 32, 64ths, 1, 0.5mm180-409U 100mm 1, .5, 1, 0.5mm180-401U 6" 8, 16, 32, 64ths (4R)180-402U 6" 32, 64, 50, 100ths (16R)180-403U 6" x 150mm 32, 64ths, 1, 0.5mm180-405U 150mm 1, .5, 1, 0.5mm180-501U 12” 8, 16, 32,64ths (4R)180-502U 12” 32, 64, 50,100ths (16R)180-503U 12” x 300mm 32, 64ths, 1, 0.5mm+.004” (+0.1mm)-.0035” (-0.09mm)+.005”(+0.13mm-.0035”(-0.09mm)180-505U 300mm 1, .5, 1, 0.5mm +.006” (+0.15mm)180-701U 18” 8, 16, 32,64ths (4R)-.0035” (-0.09mm)180-702U 18” 32, 64, 50,100ths (16R)180-703U 18” x 450mm 32, 64ths, 1, 0.5mm180-705U 450mm 1, .5, 1, 0.5mm180-601U 24” 8, 16, 32,64ths (4R)180-602U 24” 32, 64, 50,+.007” (+0.18mm)100ths (16R)180-603U 24” x 600mm 32, 64ths, 1, 0.5mm -.0035” (-0.09mm)180-605U 600mm 1, .5, 1, 0.5mm180-501U180-808U180-809UDouble Square SetSERIES 180InchCast iron-not hardened square setsSet Order BladeDouble Square HeadNo. SizeType180-808U 4" 4R 180-406U 180-113U180-809U 6" 4R 180-401U 180-113UUS-1001E-37