DIGITAL PIANO - MIDI Manuals

4. PROGRAM CHANGEData format: [CnH] -> [ppH]CnH = Program event (n = channel number)ppH = Program change numberP.C.#=Program Change numberYDP-131/YDP-213 MSB LSB P.C.#Grand Piano 1 0 122 1Grand Piano 2 0 112 1E.Piano 0 122 6Harpsichord 0 122 7Church Organ 0 123 20Strings 0 122 49• When program change reception is turned OFF, no programchange data is transmitted or received.• When you specify a program change as a number in therange of 0-127, specify a number that is one less than the programchange number listed above. For example, to specifyprogram change number 1, you would specify programchange 0.5. Pitch Bend Change[EnH] -> [ccH] -> [ddH]ccH = LSBddH = MSB6. SYSTEM REALTIME MESSAGES[rrH]F8H: Timing clockFAH: StartFCH: StopFEH: Active sensingData Transmission ReceptionF8HFAHFCHFEHTransmitted every96 clocksSong startSong stopTransmitted every200 millisecondsReceived as 96-clock tempo timingwhen MIDI clock is set to External.Song startNot received when the MIDI clock isset to Internal.Song stopNot received when the MIDI clock isset to Internal.If a signal is not received via MIDI formore than 400 milliseconds, thesame processing will take place for AllSound Off, All Notes Off and Reset AllControllers as when those signals arereceived.• If an error occurs during MIDI reception, the Damper, Sostenuto,and Soft effects for all channels are turned off and an AllNote Off occurs.7. SYSTEM EXCLUSIVE MESSAGES(Universal System Exclusive)(1) Universal Realtime MessageData format: [F0H] -> [7FH] -> [XnH] -> [04H] -> [01H] ->[llH] -> [mmH] -> [F7H]MIDI Master Volume• Simultaneously changes the volume of all channels.• When a MIDI master volume message is received, the volumeonly has affect on the MIDI receive channel, not the panelmaster volume.F0H = Exclusive status7FH = Universal Realtime7FH = ID of target device04H = Sub-ID #1=Device Control Message01H = Sub-ID #2=Master VolumellH = Volume LSBmmH = Volume MSBF7H = End of ExclusiveorF0H = Exclusive status7FH = Universal RealtimeXnH = When n is received n=0~F, whichever is received.X = don’t care04H = Sub-ID #1=Device Control Message01H = Sub-ID #2=Master VolumellH = Volume LSBmmH = Volume MSBF7H = End of Exclusive(2) Universal Non-Realtime Message (GM On)General MIDI Mode OnData format: [F0H] -> [7EH] -> [XnH] -> [09H] -> [01H] ->[F7H]F0H = Exclusive status7EH = Universal Non-Realtime7FH = ID of target device09H = Sub-ID #1=General MIDI Message01H = Sub-ID #2=General MIDI OnF7H = End of ExclusiveorF0H = Exclusive status7EH = Universal Non-RealtimeXnH = When received, n=0~F.X = don’t care09H = Sub-ID #1=General MIDI Message01H = Sub-ID #2=General MIDI OnF7H = End of ExclusiveWhen the General MIDI mode ON message is received, theMIDI system will be reset to its default settings.This message requires approximately 50ms to execute, sosufficient time should be allowed before the next message issent.147YDP-131/YDP-213 Appendix/Anhang/Annexe/Apéndice 41