INFP - INFINITY Process Panel Meter DC Current ... - NEWPORT

Parts of the Meter 4ITEMDESCRIPTIONTo return to the actual process display, without resetting the lowvaluememory, press the ‘MIN’ button once again.To reset the memory for current-value readings (start a newobservation period), press the ‘RESET’ button once and themeter will return to the run mode.In the configuration mode, once in a submenu (like input type)the ‘MIN’ button allows you scroll through the available choicessuch as, 0-20 mA or 4-20 mA, etc.In the SETPT mode, the ‘MIN’ button advances the flashing digitto the right.6 MENU BUTTONIn the run mode, this button terminates the measurementprocess and allows you to enter the configuration mode,advancing through the configuration menus.In the configuration mode, this button will store changes in thenon-volatile memory at the same time advancing the display tothe next menu item.7 RESET BUTTONIn the run mode, pressing the ‘RESET’ button once erases thememories of peak (“HI RDG”), valley (“LO RDG”), and ALARMlatches. The display then returns to the run mode.WARNING: Pressing the ‘RESET’ button two (2) times willresult in a hard reset of the meter. This will clear the Peak &Valley, Alarm latches and meter reading and immediately begina new measurement.In the configuration mode, pressing the ‘RESET’ button once,displays the previous selection. For example, if you were in “INCNF” then pressed the ‘RESET’ button once, the display willthen show “RD.SC.OF”. Press the ‘RESET’ button two times toreturn to the run mode.9