INFP - INFINITY Process Panel Meter DC Current ... - NEWPORT

Setup 5WARNING: Do not “turn-on” the ac power and input signals until allconnections are connected to the meter.11. Set P1, the AC power connector, aside and connect or reconnect allother connectors to the back of the meter using Figures 4-3 and 4-4 inSection 4.2 as guides.Connect P1 last.Note ☞NOTE: The P1 connector is “keyed”; it is shaped in such a way that it fitsonly the J1 male pins.12. Replace the rear protective cover and secure it with the cover mountingscrew.Your meter is now ready for operation and you can turn-on the power.The meter display should light, and pass through “RESET 2” to run ordisplay mode. If the meter flashes an overscale or overload message, pressthe ‘MENU’ button to advance to the configuration mode. Do not beconcerned about overloads (the +S input can stand 120 V continuously andcurrent inputs can handle ten times rated current).25