INFP - INFINITY Process Panel Meter DC Current ... - NEWPORT

Setup 55.2.4 How to Access JumpersTo gain access to jumper S1 and S2 used to configure input type remove themounting sleeve. The jumpers may be accessed through the slot in thecase.To gain access to jumpers on the main board for power, excitation andlockout selection:1. “Reveal the main board” (refer to Section 5.2, Disassembly).Note ☞NOTE: To access the S1 and S2 jumpers on the Signal Input Board, youonly need to remove the mounting sleeve.2. To re-assemble the meter, follow the steps in reverse order.Figures 5-5 through 5-13 show the layout of the seven (7) printed circuitboards with respective jumper blocks, where applicable, used in the meter.Figures 5-7 through 5-13 show the optional boards.B E K M RA B S1 A D G H L P S T U VC F JN QS2TOP VIEWSJ9J3Figure 5-5. Signal Input Board19