INFP - INFINITY Process Panel Meter DC Current ... - NEWPORT

Scaling to Display Engineering Units 8METHOD FOR SCALING THE METER TO DISPLAY INENGINEERING UNITS8.1 INTRODUCTIONThere are two basic methods for scaling your meter to display engineeringunits; scaling by using measured input values or scaling without connectinga sensor using assumed input values. Both methods use the Input Scale andOffset (“IN.SC.OF”) method.8.2 SETUP METER INPUT TYPE AND RANGEIf you have received your meter setup for your required input and do notrequire changes or rescaling, skip this section entirely and proceed with thenormal use of your meter.If you received your meter and you only require a scaling change, proceedwith the steps in Section 8.3.If you received your meter and it has been configured for input other thanwhat you require, you must proceed with the following steps before rescalingthe display:WARNING: You must set your jumper positions at the S1 and S2 positionsBEFORE proceeding. Refer to Section 6 for jumper positions.35