ALBATROS PJ-1304NX OPERATION INSTRUCTIONS - Mutoh
ALBATROS PJ-1304NX OPERATION INSTRUCTIONS - Mutoh
ALBATROS PJ-1304NX OPERATION INSTRUCTIONS - Mutoh
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Understanding the control panel & printer controls Albatros <strong>PJ</strong>-<strong>1304NX</strong> Operation Instructions<br />
PRINT PARAMETER: PLATEN HEATER<br />
* Online *<br />
Ready to Print<br />
* Print Parameter *<br />
This specifies the temperature of the platen heater. Select the optimum<br />
conditions to suit the type of printing media.<br />
Range [Off / 35 to 45 to 50°C]<br />
Setting a high platen temperature tends to make printing dots with a<br />
smaller diameter (reduced dot gain).<br />
However, if the setting temperature is too high, it may produce large<br />
stripes. (Conditions differ with the type of media.) If this happens, either<br />
lower the platen heater temperature setting or turn off the platen heater.<br />
Setup ><br />
* Print Parameter *<br />
Platen Heater ><br />
* Platen Heater *<br />
* Platen Heater *<br />
* Platen Heater *<br />
* Online *<br />
Ready to Print<br />
35° C<br />
Off<br />
Off<br />
Step 1:<br />
From the online status display, press the [PARAMETER] key<br />
to shift to the print parameter menu.<br />
Step 2:<br />
Press the [NEXT/+] or [LAST/-] keys to select “Platen<br />
Heater” from the four Parameter options: “Setup”, “Density”,<br />
“Platen Heater” and “Wiping interval” on the print parameter<br />
menu.<br />
Step 3:<br />
Press the [ENTER] key to confirm Platen Heater.<br />
Step 4:<br />
Press the [NEXT/+] or [LAST/-] keys to select the desired<br />
platen heater temperature.<br />
Step 5:<br />
Press the [ENTER] key to confirm the platen heater<br />
temperature.<br />
Step 6:<br />
After confirming the details, press the [ONLINE] key.<br />
Step 7:<br />
Online status is restored.<br />
Page 62 AP-75013, Rev. 1.0. - 05/07/01