ALBATROS PJ-1304NX OPERATION INSTRUCTIONS - Mutoh

Printing with the PJ-1304NX Albatros PJ-1304NX Operation Instructions
After you have done the switching off procedure, the printer will
automatically turn itself off.
* Online *
* Power off Sequence *
• Don’t disconnect the power cable during the printer power-off
sequence.
• The printer cannot go into the power-off sequence if the lever is up or
a cover is open. Take appropriate measures to restore normal
conditions in accordance with error messages before switching off.
• Don’t leave the printer switched off for long periods. Switch on at least
within three days.
• Even if the printer is not to be used for more than three days, it should
be switched on for half a day every three days. Keep the inks in good
condition by stirring the inks in the ink tanks with power on at certain
intervals.
• When switching the power off, every time check if the printer goes
through the power-off sequence normally. In order to confirm if the
printer goes through the power-off sequence normally, please check
the following operations.
① Stand at the back of the printer.
② Open the back cover.
③ Look up the internal area of the printer from the low back direction of
the back side of the printer, and check with your eyes to see if all ink
tubes going through the print head from the electromagnetic valve (1)
on the sub tank (2), are filled with clear liquid (jetwash).
④ Close the back cover.
2
1
Page 82 AP-75013, Rev. 1.0. - 05/07/01