Aaton 35 - Panavision

THE CAMERA BODYbody. When snug, tighten the knurled screw onto the battery tab tohold it in place.When running AatonCode, get into the practice of having a freshbattery on hand before removing the one from the camera. Even alow battery that no longer runs the body (below 10V) will haveenough voltage to keep accurate time counting.Thanks to a super capacitor built into the camera base you will havea full minute to change the battery before time is lost. After replacingthe battery, confirm that time is still counting by checking thecontrol panel.2.7.2 Battery ChargingThe Aaton on-board can be recharged with an appropriate 12Vnicad battery charger.For the best results, use a microprocessor-controlled charger or astandard trickle charger with a charging output of at least 200ma,both of which prevent of the overheating and mistreatment of yournicad cells. Always follow the specific guidelines of the chargermanufacturer. You can use the Aaton Chr1, designed to charge twostandard batteries in 6 hours, without any risk.Beware of older, timed chargers manufactured when 1.2 and 1.4ah31