Sipura SPA3000 User Guide - MyNetFone

esources are available per SPA. Therefore it is important to disable the use of G.729a in order toguarantee the support of 2 simultaneous G.723/G.726 codec.3.4.5.4. Dial PlanSee section 6 for additional information regarding the configuration of the SPA dial plan.Parameter Name Description DefaultDial Plan Per-line dial plan script See belowEnable IP Dialing Enable IP Dialing noSee the previous section for explanation of Dial Plan Script syntax.Default Dial Plan script for each line:“(*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxx|xxxxxxxxxxxx.)”Explanation of Default Dial Plan:Dial Plan Entry*xxFunctionalityAllow arbitrary 2 digit star code[3469]11 Allow x11 sequences0 Operator00 Int’l Operator[2-9]xxxxxx1xxx[2-9]xxxxxxUS "local" numberUS 1 + 10-digit long distance numberxxxxxxxxxxxx. Everything else (Int’l long distance, FWD, ...)Note: If IP dialing is enabled, one can dial [user-id@]a.b.c.d[:port], where ‘@’, ‘.’, and ‘:’ are dialed byentering “*”, user-id must be numeric (like a phone number) and a, b, c, d must be between 0 and255, and port must be larger than 255. If port is not given, 5060 is used. Port and User-Id areoptional. If the user-id portion matches a pattern in the dial plan, then it is interpreted as a regularphone number according to the dial plan. The INVITE message, however, is still sent to the outboundproxy if it is enabled.3.4.5.5. Polarity SettingsParameter Name Description DefaultIdle Polarity Polarity before call connected ForwardCaller Conn Polarity Polarity after outbound call connected ReverseCallee Conn Polarity Polarity after inbound call connected ReverseNotes:3.4.6. User 1 and User 2 Parameters© 2003 - 2004 Sipura Technology, Inc Proprietary (See Copyright Notice on Page 2) 25