Sipura SPA3000 User Guide - MyNetFone

More documents

Recommendations

Info

3.4.7. Regional Parameters3.4.7.1. Call Progress TonesParameter Name Description DefaultDial Tone 1Played when prompting the user to enter aphone number350@-19,440@-19;10(*/0/1+2)Second Dial Tone An alternative to when usertries to dial a 3-way call420@-19,520@-19;10(*/0/1+2)Outside Dial Tone 1 An alternative to usually used 420@-16;10(*/0/1)to prompt the user to enter an externalphone number (versus an internalextension). This is triggered by a “,”character encountered in the dial plan.Prompt Tone 1 Played when prompting the user to enter acall forward phone number520@-19,620@-19;10(*/0/1+2)Busy TonePlayed when a 486 RSC is received for anoutbound call480@-19,620@-19;10(.5/.5/1+2)Reorder Tone 1,2 Played when an outbound call has failedor after the far end hangs up during anestablished call480@-19,620@-19;10(.25/.25/1+2)Off Hook WarningTone 2Played when the subscriber does notplace the handset on the cradle properly480@-10,620@0;10(.125/.125/1+2)Ring Back Tone Played for an outbound call when the farend is ringing440@-19,480@-19;*(2/4/1+2)Confirm Tone This should be a brief tone to notify theuser that the last input value has been600@-16;1(.25/.25/1)"accepted.SIT1 ToneAn alternative to playedwhen an error occurs while making anoutbound call. The RSC to trigger this toneis configurable (see Section ???)985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)SIT2 Tone See 914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/3,0/4/0)SIT3 Tone See 914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)SIT4 Tone See 985@-16,1371@-16,1777@-16;20(.380/0/1,.274/0/2,.380/0/3,0/4/0)MWI Dial Tone 1Cfwd Dial ToneThis tone is played instead of when there are unheard messages in thesubscriber’s mail boxSpecial dial tone played when call forwardall is activated350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2)350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2)© 2003 - 2004 <strong>Sipura</strong> Technology, Inc Proprietary (See Copyright Notice on Page 2) 28
Holding ToneConference ToneSecure CallIndication ToneIndicate to the local user that the far endhas placed the call on holdPlays to all parties when a 3-wayconference is in progressThis tone is played when a call issuccessfully switched to secure mode. Itshould be played only for a short while (
Page 7 and 8: The SPA has the following interface
Page 9 and 10: Note: This translation convention o
Page 11 and 12: Check SPA’s Web ServerPort170 Non
Page 13 and 14: http:///resync?[[protocol://][serve
Page 15 and 16: Log Resync FailureMsgGPP A thru GPP
Page 17 and 18: SIT2 RSC 1SIT3 RSC 1SIT4 RSC 1Try B
Page 19 and 20: Ext IPExt RTP Port MinNAT Keep Aliv
Page 21 and 22: SIP 100REL EnableBlind Attn-XferEna
Page 23 and 24: The SPA provides native support of
Page 25 and 26: esources are available per SPA. The
Page 27: Parameter Name Description DefaultC
Page 31 and 32: voltage is removed after the caller
Page 33 and 34: Feature Dial Services Codesprocesse
Page 35 and 36: GMT+02:00, …, GMT+13:00FXS Port I
Page 37 and 38: Hook StateRegistration StateLast Re
Page 39 and 40: would be highly undesirable especia
Page 41 and 42: The FXS interface is the same as th
Page 43 and 44: - VoIP1-to-VoIP2 and VoIP2-to-VoIP1
Page 45 and 46: set to “none” (and so the appl
Page 47 and 48: dialed-number is not specified or i
Page 49 and 50: switch (for US telcos, this value s
Page 51 and 52: is a SIP Re-INVITE request which th
Page 53 and 54: destination. This is Call Type #5 a
Page 55 and 56: [Line 1] = fwd.pulver.com[Line 1] =
Page 57 and 58: If Line 1 is busy when the PSTN lin
Page 59 and 60: - The and parameters still apply
Page 61 and 62: VoIP Caller IDPatternlink. Choose f
Page 63 and 64: PSTN Access ListPSTN Caller 1 PINPS
Page 65 and 66: Min CPC Durationdetection5. 6 segme
Page 67 and 68: 4.14.10. Line 1 - VoIP Fallback To
Page 69 and 70: 4.14.18. PSTN User - PSTN Ring Thru
Page 71 and 72: This section of the Administration
Page 73 and 74: User Action Required to Activate or
Page 75 and 76: 5.2.6. Call-Waiting with Caller IDS
Page 78 and 79:
Dial the number of the 3 rd party.W
Page 80 and 81:
not ring or provide call waiting wh
Page 82 and 83:
service is activated or deactivated
Page 84 and 85:
The SPA syntax for the dial plan cl
Page 86 and 87:
Interdigit Timer Master Override:Th
show all

Sipura SPA3000 User Guide - MyNetFone

Create successful ePaper yourself

Delete template?

Save as template?