3820 UG.book - Finn-ID

Note: Scanning this bar code also causes both the scanner and the base toperform a reset and become unlinked. Refer to "Scanner Modes" onpage 1-6 for additional information.Standard Product Default Settings:Current Application GroupResetting the Standard Product Default Settings: AllApplication Work GroupsThe following bar code defaults all of the work groups to the factory settings.Standard Product Default Settings:All Application GroupsThe Menu Commands starting on page 10-6 list the standard product defaultsettings for each of the commands (indicated by an asterisk (*) on theprogramming pages).Temporary Visual Xpress ConfigurationFor quick download communication configuration, scan the Visual Xpress barcode to temporarily configure the imager for Visual Xpress settings. Refer toVisual Xpress on page 10-1 for additional information about Visual Xpress.Note: Connect the imager using RS-232 cables. Scan the bar code below andthe unit will communicate in RS-232 mode, allowing it to work with VisualXpress. The imager reverts to the original or reprogrammed interfacewhen the power is cycled.Visual XpressNote: If you download new software into a unit, the user-programmedparameters are retained. If you need to discard user-programmedsettings, scan the Standard Product Default Settings bar code (seeResetting the Standard Product Default Settings: Current ApplicationWork Group on page 8-2).2020/3820 User’s Guide 8 - 3