3820 UG.book - Finn-ID

Note: Scanning zero (0) is the equivalent of setting no time-out.If there are no trigger pulls during the “scanner power time-out timer” interval, thescanner goes into power down mode. Whenever the trigger is enabled, the“scanner power time-out timer” is reset. If the scanner is placed in the 2020-5Bcradle and the battery is in the process of being charged, the scanner will not gointo power down mode.0 seconds200 seconds400 seconds900 seconds* 3600 secondsNote: When the scanner is in power down mode, pull the trigger to power theunit back up. There will be a set of power up beeps and a delay of up toa few seconds for the radio to join. The scanner will then be ready to use.Automatic Trigger7200 secondsThe scanner scans continuously at full power with illumination fully on.Automatic TriggerPresentation ModeThe LEDs are off until a bar code is presented to the scanner. Then the LEDsturn on automatically to read the code. Presentation Mode uses ambient light todetect the bar codes. If the light level in the room is not high enough,Presentation Mode will not work properly.Presentation Mode2020/3820 User’s Guide 3 - 5