3820 UG.book - Finn-ID

Note: If you are out of range when you scan a bar code, you will receive an errorbeep even if you do not have the alarm set. You receive the error beepsince the data could not be communicated to the base or the host.Alarm Sound TypeIf you have set the out-of-range alarm enabled, you may change the alarm typefor the scanner or base by scanning the appropriate bar code below and thenscanning a digit (0-7) bar code and the Save bar code on the Programming Chartinside the back cover of this manual. Default = 0. Set the sound type to fit yourapplication.Base Alarm TypeScanner Alarm TypeData Accumulation ModeScan the bar codes below to turn data accumulation (batch) mode on and off. Ifdata accumulation mode is on, bar code data is stored when the scanner is outof range of the base and transmitted once the scanner is back in range.Data Accumulation Mode On* Data Accumulation Mode OffBeeper and LED Sequences and Their MeaningThe 3820 contains LEDs on the top of the unit to indicate its power up,communication, and battery status. Simply stated, red LED = error; greenLED = success of any type. The unit’s audible indicators have meaning as well:3 beeps = error; 2 beeps = menu change; 1 beep = all other successes.The table below lists the indication and cause of the LED illumination and beepsfor the 3820.1 - 14 2020/3820 User’s Guide