3820 UG.book - Finn-ID

Changing Scanner Name - via Bar CodesIf you wanted to set up your scanners with names 0001-0007, you may scan thebar codes below. Scan the Reset bar code after each name change and wait forthe scanner to re-link to the base before scanning the next bar code to name thenext scanner.0001000200030004000500060007ResetAlternatively, you may change the name with a bar code command if you cannotsend serial commands to the base. One way to do this is to scan the bar codebelow and scan a number for the scanner name. For example, if you had 7scanners to one base, scan the bar code below with the first scanner, scan the1 bar code on the Programming Chart inside the back cover of this manual andscan Save. Then scan the Reset bar code and wait for the scanner to re-link tothe base before scanning the next bar code. Repeat that process for scannernumber 2, 3, 4 etc.Scanner NameIf you want to assign an alphabetic name to the scanner, create a Code 128 barcode containing “~BT_NAMname.” followed by a FNC3 character (hexidecimal83), where name is the new scanner name. Scan the Reset bar code (page 1-9or on the Programming Chart inside the back cover of this manual). You mayuse Barcode Builder, which is included with Quick*View. You may downloadQuick*View from the Hand Held Products website: www.handheld.com.2020/3820 User’s Guide 1 - 9