CF-V 31-41-51-71-91-101- 121-142-182-202-242 - Delta-Temp

MANUAL PURPOSEThis manual has been designed to enable the unit to beinstalled, started up and maintained correctly.MANUAL INSTRUCTIONSIt is essential to observe these instructions.The manufacturer declines all liability for any damage thatmay be caused whether directly or indirectly to persons orthings if these instructions are not heeded.MANUAL STORAGEThis manual and the unit’s wiring diagram should becarefully stored so that they are readily available to theoperator when required.EXPERT PERSONALThe unit must be installed, tested and maintained by expertpersonal who meet the relevant legal requirements (Italianlaw No. 46 of 5/3/1990).LOCAL SAFET REGULATION INSTALLATIONThe installation must be performed observing the localsafety regulations.POWER SUPPLYMake sure the power supply conforms to the data on theunit’s rating plate, located inside the door of the mainelectrical panel.PACKAGINGThe packaging material (plastic bags, polystyrene foam,nails, etc.) is potentially dangerous and should therefore bekept away from children and recycled in compliance withthe local regulations in force.MAINTENANCEBefore performing any service operations, cut off the power.Perform the operations in conformity with the localregulations in force.PERIODICAL INSPECTIONSPerform periodical inspections to locate possible loosenedor broken parts. If the repairs are not performed, there willbe a higher risk for things and peoples to become damagedand injured.FAULT – POOR OPERATIONSwitch off the unit in the event of faults or poor operation.REPAIROnly have repairs carried out by a service centre authorisedby the manufacturer, and insist on the use of original spareparts only.Failure to comply with the above may compromise thesafety of the unit.MODIFICATIONSThe manufacturer will not accept any responsibility, and thewarranty will lapse, in the event of electric and/ormechanical modifications. Any modification which is notformally authorized, and which does not respect theinstructions given in this manual, will cause the warranty tolapse.INTENDED USEThe unit must only be used for the specific purpose it wasdesigned :GENERAL WARNINGSThe unit is designed for civil air-conditioning within thelimits defined in the technical bulletin and this manual.Any use other than that specified does not imply anycommitment or constraint by the manufacturer in any waywhatsoever.ADDITIONAL SAFETY PRECAUTIONSThis unit has been especially designed and manufacturedso to prevent any risk to persons and health hazard.For this reason, design solutions fit to eliminate (wherepossible) any cause of risk and sensibly reduce theprobability of danger have been adopted.Please refer to the "Residual Risks" section of this manualand strictly observe the behaviour prescriptions listed therein order to prevent any possible risk that hasn’t beenpossible to avoid in the design stage.DATA UPDATINGThe manufacturer may be able to modify the data withoutprior notice as a consequence of constant improvements.REGULATIONS ANDCERTIFICATIONSUNI EN ISO 9001 CERTIFICATIONClivet S.p.A., in order to guarantee customer satisfaction,has chosen the ISO 9001 Quality System as the referencefor all its business activities. This is demonstrated by thecompany’s commitment to ongoing improvements in thequality and reliability of its products; its sales, design,purchasing, production and after-sales service activities arethe means used to reach such purpose.CE MARKClivet products bear the CE mark, in compliance with therequirements of the following EC directives, including thelatest amendments, and with the corresponding nationalapproximated legislation:• - 98/37/CE• - 89/336/CEE as modified by the directives 92/31/CEEand 93/68/CEE• - 73/23/CEE as modified by the directive 93/68/CEE• - 97/23/CEM23740N6-03 01/10/07 page 5