POWERTECHÃ¢Â„Â¢ 2.9 L OEM Diesel Engines - John Deere Industrial ...

More documents

Recommendations

Info

Engine Operating GuidelinesCAUTION: Before starting engine in a confinedbuilding, install proper outlet exhaustventilation equipment. Always use safetyapproved fuel storage and piping.NOTE: If temperature is below 0 °C (32 °F), it may benecessary to use cold weather starting aids (SeeCOLD WEATHER OPERATION, later in thissection).1. Perform all prestarting checks outlined in Lubrication &Maintenance/Daily Section later in this manual.Avoid Toxic FumesTS220 –UN–23AUG882. Open the fuel supply shut-off valve, if equipped.RG,RG34710,5049–19–30JAN98–2/43. If equipped with PTO clutch, pull lever (arrow) rearward(away from engine) to disengage PTO clutch.PTO Clutch LeverRG5602 –UN–16JUN00Continued on next pageRG,RG34710,5049–19–30JAN98–3/415-10 060106PN=50
Engine Operating Guidelines4. Pull hand throttle (A) 1/3 of the way out. Turn thehandle in either direction to lock it in place.5. If equipped, depress and hold reset button (B) whilestarting.IMPORTANT: Do not operate the starter for more than30 seconds at a time. To do so mayoverheat the starter. If the engine doesnot start the first time, wait at least 2minutes before trying again. If enginedoes not start after four attempts, seeTroubleshooting Section.6. Turn the key switch (C) clockwise to crank the engine.When the engine starts, release the key so that itreturns to the “ON” position.IMPORTANT: If the key switch is released before theengine starts, wait until the starter andthe engine stop turning before tryingagain. This will prevent possibledamage to the starter and/or flywheel.7. After the engine starts, continue to hold the resetbutton in until the oil pressure gauge (D) reads at least105 kPa (1.05 bar) (15 psi). The safety controls will notallow the engine to run at a lower oil pressure unlessthe reset button is held in.North American Instrument PanelRG11532 –UN–01DEC00IMPORTANT: Should the engine die while operatingunder load, immediately disengage PTOclutch and restart the engine.Overheating of turbocharger parts mayoccur when oil flow is stopped.8. Check all gauges for normal engine operation. Ifoperation is not normal, stop the engine and determinethe cause.A—Hand ThrottleB—Reset ButtonC—Key SwitchD—Oil Pressure GaugeAEZ Instrument Panel (Except North America)RG11592 –UN–17JAN01VDO Instrument Panel (Except North America)RG11588 –UN–08DEC00RG,RG34710,5049–19–30JAN98–4/415-11 060106PN=51
Page 1 and 2: POWERTECH 2.9 LOEM DieselEnginesOPE
Page 3 and 4: IntroductionEngine OwnerJohn Deere
Page 5 and 6: IntroductionIdentification Views—
Page 7 and 8: ContentsPagePageRecord Keeping Warm
Page 9 and 10: Record KeepingEngine Serial Number
Page 11 and 12: Record KeepingOption Codes Descript
Page 13 and 14: SafetyRecognize Safety InformationT
Page 15 and 16: SafetyPrepare for EmergenciesBe pre
Page 17 and 18: SafetyHandle Chemical Products Safe
Page 19 and 20: SafetyAvoid High-Pressure FluidsEsc
Page 21 and 22: SafetyInstall Fan GuardsRotating co
Page 23 and 24: SafetyPrevent Acid BurnsSulfuric ac
Page 25 and 26: Fuels, Lubricants, and CoolantDiese
Page 27 and 28: Fuels, Lubricants, and CoolantBio-D
Page 29 and 30: Fuels, Lubricants, and CoolantMinim
Page 33 and 34: Fuels, Lubricants, and CoolantOILSC
Page 37 and 38: Fuels, Lubricants, and CoolantAddit
Page 39 and 40: Fuels, Lubricants, and CoolantSuppl
Page 41 and 42: Engine Operating GuidelinesInstrume
Page 43 and 44: Engine Operating GuidelinesLater In
Page 45 and 46: Engine Operating GuidelinesAEZ Inst
Page 47 and 48: Engine Operating GuidelinesVDO Inst
Page 49: Engine Operating GuidelinesAuxiliar
Page 53 and 54: Engine Operating GuidelinesAEZ Inst
Page 55 and 56: Engine Operating GuidelinesNormal E
Page 57 and 58: Engine Operating GuidelinesWarming
Page 59 and 60: Engine Operating GuidelinesStopping
Page 61 and 62: Engine Operating GuidelinesUsing A
Page 63 and 64: Lubrication and MaintenanceObserve
Page 65 and 66: Lubrication and MaintenanceLubricat
Page 67 and 68: Lubrication and MaintenanceLubrican
Page 69 and 70: Lubrication & Maintenance/DailyDail
Page 71 and 72: Lubrication & Maintenance/DailyLubr
Page 73 and 74: Lubrication & Maintenance/DailyChec
Page 75 and 76: Lubrication & Maintenance/250 Hour/
Page 99 and 100: Lubrication&Maintenance/2000 Hour/2
Page 101 and 102:
Lubrication&Maintenance/2000 Hour/2
Page 103 and 104:
Lubrication&Maintenance/2000 Hour/2
Page 105 and 106:
Service As RequiredAdditional Servi
Page 107 and 108:
Service As RequiredBleeding The Fue
Page 109 and 110:
Service As RequiredAt Fuel Injectio
Page 111 and 112:
Service As RequiredIMPORTANT: Whene
Page 113 and 114:
Service As RequiredCAUTION: Only a
Page 115 and 116:
Service As RequiredChecking FusesTh
Page 117 and 118:
TroubleshootingGeneral Troubleshoot
Page 119 and 120:
TroubleshootingA1—Speed Control U
Page 121 and 122:
TroubleshootingSymptom Problem Solu
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
StorageEngine Storage Guidelines1.
Page 139 and 140:
StorageRemoving Engine from Long Te
Page 141 and 142:
SpecificationsNOTE: Engine models l
Page 143 and 144:
SpecificationsENGINE OPTION FUEL IN
Page 145 and 146:
SpecificationsCD3029TF121 1602 RE53
Page 147 and 148:
SpecificationsEngine Model Dipstick
Page 149 and 150:
SpecificationsUnified Inch Bolt and
Page 151 and 152:
Lubrication and Maintenance Records
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Emission System WarrantyU.S. Emissi
Page 159 and 160:
John Deere Service Literature Avail
Page 161 and 162:
IndexPagePageAAcid burns ..........
Page 163 and 164:
IndexPagePageP Lubrication system .
show all

POWERTECHÃ¢Â„Â¢ 2.9 L OEM Diesel Engines - John Deere Industrial ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?