Installatiefiche - Delta-Temp

CONTROL 7MASTER SLAVE ADDRESSINGThe units must be addressed as indicated in the tablesideways .Addressing procedure:1. set pGD keypad = 02. set the base card as indicated in the table3. set pGD keypad as indicated in the table4. proceed with the other unitsUnit PCO3 base card pGD keypadUnit 1 1 15Unit 2 2 16Unit 3 3 17Unit 4 4 18Unit 5 5 19Unit 6 6 20Unit 7 7 21Unit 8 8 22Unit 9 9 23Unit 10 10 241 set the pGD keypad = 0Press for 5 secondsdisplay address setting......32set = 0display address changed2 set the base card as indicated in the tablePress at the same timeselftest please waitKeep pressed for 10 sec pLan address = 0set as indicated in the tableconfirm3 set the pGD keypad as indicated in the tableRepeat the procedure as at point 127