HTI Manual - Desert Tactical Arms

More documents

Recommendations

Info

12of the hand guard (7).• The bolt assembly travels inside of the receiver; the bolt handle (3) is located onthe right side of the receiver (5).• Ambidextrous safety selector (14) is located above the trigger guard, on the rightand left side of the firearm.• The buttpad (11) is attached to the rear end of the receiver (5).
DISASSEMBLY AND ASSEMBLY1. This chapter deals with the disassembly and assembly operations which the usermay perform for routine maintenance of the rifle. Disassembling or assemblingof any other part is not recommended. Any damage caused from improper disassemblywill void warranty.2. Disassembly must be carried out on a clean surface and disassembled partsshould be placed in order of their removal.WARNING: Carry out the following operations before dismantling: Remove magazine;clear the rifle to ensure there is no live cartridge in the chamber (see page 24).CAUTION: FOREARM IS ATTATCHED TO THE RECEIVER.DAMAGE CAUSED BY THE REMOVAL OF THE FOREARMWILL VOID WARRANTY!13
Page 3 and 4: For video instructions see our webs
Page 5 and 6: CARE AND CLEANING..................
Page 7 and 8: Before shooting the rifle:• Alway
Page 9 and 10: SIGHTSPicatinny rail (no taper)BARR
Page 11 and 12: CompactRuggedThe HTI’s bullpup de
Page 13: Other Benefits• The full length M
Page 17 and 18: REMOVING BARREL1. Remove buttpad an
Page 19 and 20: 3. Make sure the barrel is fully se
Page 22 and 23: 6. Ease the spring and follower out
Page 24 and 25: REMOVING STOCK PANELS221. Place the
Page 26 and 27: LOADING AND UNLOADINGINSERTING THE
Page 28 and 29: UNLOADING (CLEARING) THE HTI1. Plac
Page 30 and 31: ADJUSTING CHEEK PIECE1. With an 5mm
Page 32 and 33: 6. Install ring tops.7. Finger tigh
Page 34 and 35: QUICK ZEROING1. Find the center of
Page 36 and 37: 344. Once on paper, shoot a three s
Page 38 and 39: It is easier to train yourself to s
Page 40 and 41: INITIAL CLEANING1. Upon receipt of
Page 42 and 43: • Allow to sit for 15 minutes.•
Page 44 and 45: BEFORE AND AFTER FIRINGCLEANING BEF
Page 46 and 47: ADDITIONAL DISASSEMBLY & AS-SEMBLYB
Page 48 and 49: BOLT ASSEMBLY1. Insert the firing p
Page 50 and 51: 5. Hold the bolt with the end cap f
Page 52 and 53: 2. MAGAZINE NOT EMPTY (Malfunction)
Page 54 and 55: B. FAILURE TO CHAMBER * Bolt does n
Page 56 and 57: 4. Fouled Extractor5. Extractor Def
Page 58 and 59: PARTS EXPLODED VIEWHTI56BarrelBoltR
Page 60 and 61: MAGAZINE58Floor PlateFollowerMagazi
Page 62 and 63: PATENTS PENDINGNo part of this docu

HTI Manual - Desert Tactical Arms

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?