HTI Manual - Desert Tactical Arms

More documents

Recommendations

Info

6. Install ring tops.7. Finger tighten ring screws (leave itloose enough that the scope can stillrotate inside the rings) (fig. 29).30Figure 298. Establish eye relief• Get into your favored shooting position• Pull rifle firmly into your shoulder• Close your eyes• Affirm cheek-weld• Open your eyes• Adjust scope forward or backward until any ghost ring goes away (additionalforward or backward adjustment can be gained by moving the entirescope ring base forward or backward along the picatinny rail).
9. Place feeler gauges (and spacer ifnecessary) between bottom of thescope and the flat on ring base (fig. 30).Adjust the feeler gauges until there isa snug fit. This is for the purpose ofmaking the scope flat in relation to thescope base.CAUTION: Take caution when adjusting thefeeler gauges. Do not make fit too tight as damagemay result.Figure 3010. Tighten ring screws to 15 inch/lb., rotating from left to right in a crisscrosspattern. While you tighten, ensure feeler gauges are not too tight. They shouldalways have some left to right play.31
Page 3 and 4: For video instructions see our webs
Page 5 and 6: CARE AND CLEANING..................
Page 7 and 8: Before shooting the rifle:• Alway
Page 9 and 10: SIGHTSPicatinny rail (no taper)BARR
Page 11 and 12: CompactRuggedThe HTI’s bullpup de
Page 13 and 14: Other Benefits• The full length M
Page 15 and 16: DISASSEMBLY AND ASSEMBLY1. This cha
Page 17 and 18: REMOVING BARREL1. Remove buttpad an
Page 19 and 20: 3. Make sure the barrel is fully se
Page 22 and 23: 6. Ease the spring and follower out
Page 24 and 25: REMOVING STOCK PANELS221. Place the
Page 26 and 27: LOADING AND UNLOADINGINSERTING THE
Page 28 and 29: UNLOADING (CLEARING) THE HTI1. Plac
Page 30 and 31: ADJUSTING CHEEK PIECE1. With an 5mm
Page 34 and 35: QUICK ZEROING1. Find the center of
Page 36 and 37: 344. Once on paper, shoot a three s
Page 38 and 39: It is easier to train yourself to s
Page 40 and 41: INITIAL CLEANING1. Upon receipt of
Page 42 and 43: • Allow to sit for 15 minutes.•
Page 44 and 45: BEFORE AND AFTER FIRINGCLEANING BEF
Page 46 and 47: ADDITIONAL DISASSEMBLY & AS-SEMBLYB
Page 48 and 49: BOLT ASSEMBLY1. Insert the firing p
Page 50 and 51: 5. Hold the bolt with the end cap f
Page 52 and 53: 2. MAGAZINE NOT EMPTY (Malfunction)
Page 54 and 55: B. FAILURE TO CHAMBER * Bolt does n
Page 56 and 57: 4. Fouled Extractor5. Extractor Def
Page 58 and 59: PARTS EXPLODED VIEWHTI56BarrelBoltR
Page 60 and 61: MAGAZINE58Floor PlateFollowerMagazi
Page 62 and 63: PATENTS PENDINGNo part of this docu

HTI Manual - Desert Tactical Arms

Create successful ePaper yourself

Delete template?

Save as template?