HTI Manual - Desert Tactical Arms

ADDITIONAL DISASSEMBLY & AS-SEMBLYBOLT DISASSEMBLY1. Hold the bolt with the end cap facingaway and with your left thumb, push onthe striker tab toward the bolt handle(fig. 33).2. Using secure table or bench, hook thestriker tab on the underside, pulling thebolt away from the table while turningthe bolt counter-clockwise (fig. 34).The end cap is under pressure due tothe firing pin spring. Be aware, it willshoot out on to the floor. To avoid thisfirmly place your left index finger overthe endcap while removing it.WARNING: THE FIRING PIN SPRING IS UN-DER COMPRESSION! TAKE CAUTION WHENREMOVING THE END CAP!Figure 33Figure 3444