HTI Manual - Desert Tactical Arms

More documents

Recommendations

Info

It is easier to train yourself to stop thinking in inches and think in terms of MOA andMILS instead. Their values don’t change with distance therefore it will eliminate alot of unnecessary conversion formulas.36Conversion Formulas• Inch to MOA: Inch Value x 100 = MOA CorrectionTarget Distance• Inch to MIL: Inch Value x 100 ÷ 3.6 = MIL CorrectionTarget Distance• MOA to MIL:MOA Value= MIL Correction3.438MIL Value• MIL to MOA: = MOA Correction0.2908
CARE AND CLEANINGGENERALComprehensive knowledge of how to service and handle rifles is of great importance.Experience has shown that most failures which occur while operating the rifle are dueto negligence in maintenance. Special attention must be paid to cleaning, lubricatingand inspecting the rifle; this will determine whether or not the rifle will functionproperly. In order to maintain accuracy, the barrel must be serviced thoroughly. Thereceiver, the bolt assembly and other moving parts of the rifle must be kept clean andlightly lubricated to ensure proper operation. Care and cleaning includes the magazine,which must be kept free from rust, grit, etc., in order to function properly.37
Page 3 and 4: For video instructions see our webs
Page 5 and 6: CARE AND CLEANING..................
Page 7 and 8: Before shooting the rifle:• Alway
Page 9 and 10: SIGHTSPicatinny rail (no taper)BARR
Page 11 and 12: CompactRuggedThe HTI’s bullpup de
Page 13 and 14: Other Benefits• The full length M
Page 15 and 16: DISASSEMBLY AND ASSEMBLY1. This cha
Page 17 and 18: REMOVING BARREL1. Remove buttpad an
Page 19 and 20: 3. Make sure the barrel is fully se
Page 22 and 23: 6. Ease the spring and follower out
Page 24 and 25: REMOVING STOCK PANELS221. Place the
Page 26 and 27: LOADING AND UNLOADINGINSERTING THE
Page 28 and 29: UNLOADING (CLEARING) THE HTI1. Plac
Page 30 and 31: ADJUSTING CHEEK PIECE1. With an 5mm
Page 32 and 33: 6. Install ring tops.7. Finger tigh
Page 34 and 35: QUICK ZEROING1. Find the center of
Page 36 and 37: 344. Once on paper, shoot a three s
Page 40 and 41: INITIAL CLEANING1. Upon receipt of
Page 42 and 43: • Allow to sit for 15 minutes.•
Page 44 and 45: BEFORE AND AFTER FIRINGCLEANING BEF
Page 46 and 47: ADDITIONAL DISASSEMBLY & AS-SEMBLYB
Page 48 and 49: BOLT ASSEMBLY1. Insert the firing p
Page 50 and 51: 5. Hold the bolt with the end cap f
Page 52 and 53: 2. MAGAZINE NOT EMPTY (Malfunction)
Page 54 and 55: B. FAILURE TO CHAMBER * Bolt does n
Page 56 and 57: 4. Fouled Extractor5. Extractor Def
Page 58 and 59: PARTS EXPLODED VIEWHTI56BarrelBoltR
Page 60 and 61: MAGAZINE58Floor PlateFollowerMagazi
Page 62 and 63: PATENTS PENDINGNo part of this docu

HTI Manual - Desert Tactical Arms

Create successful ePaper yourself

Delete template?

Save as template?