Installation Manual HLF-25, 30, 40, & 50 - Waltco

More documents

Recommendations

Info

Chapter 4Electrical Schematic<strong>Installation</strong>GR02798DIVERT WATER FROM ENCLOSUREZip TieTo help prevent channeling water into pump or batteryenclosures:• Secure hoses, cables and cords downward asthey exit the enclosure.• If a downward exit is impractical, a Zip Tie canbe installed around hose or cable to helpinterrupt the flow of water as shown.Flow of waterPump or BatteryEnclosureGR02460HOSE INSTALLATIONAvoid twisting of hoses.High PressureNo PressureAvoid sharp bends when routing hosesHoses will contract under pressure. Allow plenty of slackbetween connecting points.Do not clamp hoses at bends to allow for lengthchanges when hose is pressurized.GR00717Page 22
Chapter 4REMOVE MOUNTING BAR, WEDGE BLOCKS, AND3/16” COIL PIN SHIMSInsure platform is properly supported beforedisconnecting the Mounting Bars and Wedge Blocks.<strong>Installation</strong>Mounting Bar(Each Side)Do not be under platform or lift arms whendisconnecting the Mounting Bar.Access bar from forward side of mounttube.Remove two 3/16” coil pins from platform at springretainer.Coil PinsAuto Tilt WedgeBlock (Each Side)GR02785FILLING HYDRAULIC RESERVOIRPosition liftgate deck into raise position (use forklift,crane, or other safe device if necessary).Remove Reservoir Plug.Oil level should be 1/2” from top of reservoir in raisedposition.If low, fill as required.Replace Plug with Breather.Run liftgate full cycle several times to release trappedair from system.Replace capwith BreatherGR02792Page 23
Page 1 and 2: www.waltco.com Phone: 800.411.5685p
Page 3 and 4: IntroductionIf anyone observes impr
Page 5 and 6: Liftgates with Tilt Function• Pro
Page 7 and 8: Chapter 2Liftgate Terminology19. Mo
Page 9 and 10: Chapter 3 Determine Basic Mounting
Page 11 and 12: Chapter 4InstallationCut away vehic
Page 13 and 14: Chapter 4InstallationALTERNATIVE WE
Page 15 and 16: Chapter 4InstallationBolts heads sh
Page 17 and 18: Chapter 4OPTIONAL INSTALLATIONIf th
Page 19 and 20: Chapter 4InstallationRoute control
Page 21: Chapter 4INSTALLATION OF POWER CABL
Page 25 and 26: Chapter 4There is no speed adjustme
Page 27 and 28: Chapter 4ADJUST PLATFORM TILTAdjust
Page 29 and 30: Chapter 4Waltco offers three sugges
Page 31 and 32: Chapter 4STEP ADJUSTMENTInstallatio
Page 33 and 34: Chapter 5Placement of DecalsAll dec
Page 35 and 36: Chapter 7 FINAL INSPECTION SHEETIMP
Page 37 and 38: Hand Held Remote InstallationLPF Li
Page 39 and 40: Auxiliary Battery Kit w/Dual Cables
Page 45 and 46: Installation of Cab Shut Off Switch
Page 47 and 48: HLF WALK RAMP KITINSTALLATION INSTR
Page 49 and 50: HLF WALK RAMP KITINSTALLATION INSTR
Page 51 and 52: Chapter 8How To Order PartsRepairs
Page 53 and 54: Every vehicle that has a WALTCO Lif

Installation Manual HLF-25, 30, 40, & 50 - Waltco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?