Installation Manual HLF-25, 30, 40, & 50 - Waltco

HLF WALK RAMP KITINSTALLATION INSTRUCTIONSAdjustment of Parting BarThe Parting Bar must be located in the fully retractedposition as show to right.Fully retracted Parting BarTighten nuts and bolts to 50 ft lbs.GR02799Final InspectionAfter all components from Walk Ramp Kit have beeninstalled, carefully run liftgate through a complete cycleto check for interferences.Check platform storage:- Ensure Up-Stops contact Platform Brackets- Ensure liftgate does not extend beyond steel ofDock BumperCheck platform operation:- Ensure platform does not contact Walk RampBracket nor Up-Stops when opening and closing.- If contact does occur, the Parting Bar was notadjusted or the bed height is too low.Check Up-Stopcontact &liftgate locationCheck forcontact whileopening andclosing liftgateGR0280880101571 E.O. 6708 Rev. 06Page 49