color gps plotter

9. DATA TRANSFERe i re ei i r utes ataYou may sending/receiving routes as follows. When sending data, set the connected equipmentfor receiving.teAll waypoints in a route can be transported with the route.1. Connect the PC or another GP-7000/F to the equipment.2. Choose INPUT/OUTPUT from the ADVANCED menu.3. When sending data, follow steps shown below.a) Choose NMEA 1 OUTPUT, NMEA 2 OUTPUT or RS232 3 OUTPUT appropriately.The sentence window appears.GLLVTGBWRDBTDPTMTWVHWWCVAPAAPBHDGBODXTERMARMBRMCGGAHSCAAMGTDMWVZDAOnOnOffOffOffOffOffOffOffOnOffOffOffOffOnOnOffOffOffOffOffOffWPLRTETLL OutOnOnOnSentences windowb) Choose WPL and RTE sentences and then set these on.4. When receiving data, follow steps shown below.a) Choose NMEA 1 INPUT, NMEA 2 INPUT or RS232 3 INPUT appropriately, and then pushthe [ENTER] knob.b) Communication format between this unit and PC (or GP-7000/F) should be the same.5. Press the [CLEAR] key several times to close the window and menus.