color gps plotter

10. MAINTENANCE & TROUBLESHOOTINGeriartsYou can confirm the signal input.1. Rotate the [ENTER] knob to choose Serial port from the SYSTEM TEST.2. Push the [ENTER] knob to show the Serial port window.Change parametersInput data displaySerial port3. Rotate the [ENTER] knob to choose “Change parameters” and then push the [ENTER] knob.Port: PORT2Baud Rate: 4800Data Bits: 8Parity: noneStop Bits: 14. Enter the settings for the port in use and then push the [CLEAR] key.5. Rotate the [ENTER] knob to choose “Input data display” and then push the [ENTER] knob.6. Press the [CLEAR] key twice to finish.te When choosing Input data display, the data input from the external equipment connectedare shown.rraYou can confirm the software program No by following procedure.1. Rotate the [ENTER] knob to choose “ADVANCED”, and then push the [ENTER] knob.2. Rotate the [ENTER] knob to choose “SYSTEM UPDATE”, and then push the [ENTER] knob toshow the System update menu..System UpdatePlotter SW version: 1451721-**.**SW Development No: 10.06.***Kernel: 1.03.***NTSL: 6.01.***BIOS: 1.02.***File System: 3.00.***Worldwide Charts *.**GPS: 485026****Update Plotter SoftwareUpdate Worldwide Maps*: Program version No.3. To escape from the System update menu, press the [MENU] key.