DigiTrace NGC-UIT Loader Utility - Pentair Thermal Management

More documents

Recommendations

Info

Press Exit to NGC-UIT, and remove the flash drive from the USB port once theDigiTrace NGC-30 main screen appears.Step 2C (For UIT Software versions 1.18 and higher) The UIT Software versions 1.18 and higher do not require power cycle. While theprogram is running, insert the USB flash drive with the XML file into the left sideof the DigiTrace NGC-UIT.Wait approximately one minute until the program displays the selection screen.This screen will indicate three options, as shown below:If a version of the NGC-30 UIT Software is also saved on the same USB flashdrive, this screen will indicate four options, as shown below:Step 3Choose the Select XML Database option by pressing that button on the screen.Step 4The program will list the XML files that are on your flash drive. Choose the oneyou wish to load and press the OK button at the upper right hand corner of thescreen.The program will prompt you if you want to overwrite existing database, selectyes. Once you have selected yes, the program brings you back to the abovescreen.Press Exit to NGC-UIT, and remove the flash drive from the USB port once theDigiTrace NGC-30 main screen appears.THERMAL MANAGEMENT SOLUTIONS EN-NGC30LoaderUtility-IM-H58045 04/13 14/34
2.2.2 Importing the .XML configuration file using the loader utility programThe NGC-UIT can be connected to a PC laptop, running the Loader Utility Program via threemethods: 1) RS232 Connection 2) RS-485 Connection 3) Ethernet ConnectionRS232 ConnectionThe RS-232 port can be used as a direct connection to a single PC located within 15meters (50 feet) of the panel. For an RS-232 connection, a 3-foot long RJ11 to 9-pinfemale D-connector (DigiTrace NGC-UIT-232, part number: 10332-005) has beenprovided with the DigiTrace NGC-UIT. Plug the RJ 11 connector into the RS-232connector on the DigiTrace NGC-UIT and the other end into the 9-pin male connector onthe user’s computer.THERMAL MANAGEMENT SOLUTIONS EN-NGC30LoaderUtility-IM-H58045 04/13 15/34
Page 1 and 2: 平成 24 年 9 月 21 日京都
Page 3 and 4: Section 1 Introduction1.1 WelcomeTh
Page 5 and 6: MEET YOUR REQUIREMENTS, OR THAT THE
Page 7 and 8: 1.5 Technical SupportFor technical
Page 9 and 10: Step 3Once you have entered all the
Page 11 and 12: A dialogue box will open to select
Page 13: Step 2B (For UIT Software version 1
Page 17 and 18: equired to make the connection to t
Page 19 and 20: Step 1Connect a laptop computer to
Page 21 and 22: If a version of the NGC-30 UIT Soft
Page 23 and 24: as ºF, when the circuit data is im
Page 25 and 26: Click on the Save Data button (Labe
Page 27 and 28: Select the file that should be impo
Page 29 and 30: Step 3Click on the Save to XML File
Page 31 and 32: Appendix 1. Connecting an NGC-UIT t
Page 33 and 34: Appendix 2. Procedure to Release CO

DigiTrace NGC-UIT Loader Utility - Pentair Thermal Management

Create successful ePaper yourself

Delete template?

Save as template?