DigiTrace NGC-UIT Loader Utility - Pentair Thermal Management

More documents

Recommendations

Info

Step 1Connect a laptop computer to the DigiTrace NGC-UIT via the RS-232 port.Step 2 Start the DigiTrace UIT Loader program by clicking on the icon on your desktop or by going to Start menu/Programs/Pentair ThermalManagement/DigiTrace Click on the XML to NGC-UIT tab near the top of the window.Step 3Step 4Step 5Set the NGC-UIT Port to the port that will be used to communicate to the NGC-UIT (Label F).Set the DigiTrace NGC-UIT Baud Rate and NGC-UIT Modbus Address so thatit matches the settings on the NGC-UIT’s System|Comm screen (Label A/G andLabel B/H consecutively).Set the DigiTrace NGC-UIT’s Serial Port mode is RS-232 (Label C).Set the DigiTrace NGC-UIT’s Read/Write Port to Serial (Label D).Click on the Select XML File (Label I) text field to bring up the Select XML Fileto Download dialog box.Select the file you wish to send to the NGC-UIT.Click on Open. This will fill in the Select XML File text field with the path wherethe XML file is located.Click on the Transmit button (Label J). The program will then send the datafrom the XML file to the DigiTrace NGC-UIT.RS-485 ConnectionUse the RS-485 port when multiple DigiTrace NGC-UIT units are to be connected to ahost computer or the connection is longer than 15 meters (50 feet). A converter may beTHERMAL MANAGEMENT SOLUTIONS EN-NGC30LoaderUtility-IM-H58045 04/13 16/34
equired to make the connection to the user’s PC. Depending on the available ports onthe PC, an RS-485 to RS-232 or an RS-485 to USB converter may be used.Step 1Connect a laptop computer to the DigiTrace NGC-UIT via the RS-485 port.THERMAL MANAGEMENT SOLUTIONS EN-NGC30LoaderUtility-IM-H58045 04/13 17/34
Page 1 and 2: 平成 24 年 9 月 21 日京都
Page 3 and 4: Section 1 Introduction1.1 WelcomeTh
Page 5 and 6: MEET YOUR REQUIREMENTS, OR THAT THE
Page 7 and 8: 1.5 Technical SupportFor technical
Page 9 and 10: Step 3Once you have entered all the
Page 11 and 12: A dialogue box will open to select
Page 13 and 14: Step 2B (For UIT Software version 1
Page 15: 2.2.2 Importing the .XML configurat
Page 19 and 20: Step 1Connect a laptop computer to
Page 21 and 22: If a version of the NGC-30 UIT Soft
Page 23 and 24: as ºF, when the circuit data is im
Page 25 and 26: Click on the Save Data button (Labe
Page 27 and 28: Select the file that should be impo
Page 29 and 30: Step 3Click on the Save to XML File
Page 31 and 32: Appendix 1. Connecting an NGC-UIT t
Page 33 and 34: Appendix 2. Procedure to Release CO

DigiTrace NGC-UIT Loader Utility - Pentair Thermal Management

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?