AGP Pellet Stove - Avalon

More documents

Recommendations

Info

44 Optional EquipmentWireless Thermostat Installation (Optional)DO NOT CONNECT 120 VAC OR 24V TO THE THERMOSTAT CIRCUIT OF THIS HEATER(DO NOT USE A HOUSEHOLD THERMOSTAT USED FOR A WALL-BOARD OR OTHERELECTRICAL HEATER). USE A LOW VOLTAGE COMPATIBLE THERMOSTAT.Install the thermostat as follows:Left Side of <strong>Stove</strong>1. Remove the thumb screw holding the cover in place. Remove the cover.2. Remove the two screws securing the access panel (5/16” nutdriver).3. Open the access panel.© Travis Industries 4130924 100-01330_004
Optional Equipment 454. Route the wires labeled “TSTAT” under the auger motor to the right side of the stove.5. Replace and secure the left access side panel and cover.Right Side of <strong>Stove</strong>6. Remove the knob from the air shutter rod.7. Remove the thumb screw holding the cover in place. Remove the cover.NOTE: Take care not to damage or remove the black and white nylon spacers.8. Remove the two screws securing the access panel (5/16” nutdriver).© Travis Industries 4130924 100-01330_004
Page 4: 4 Safety PrecautionsHOT WHILE IN OP
Page 7 and 8: Installation (For Qualified Install
Page 21 and 22: Safety NoticeOperation 21READ THIS
Page 23 and 24: Operation 23Manual ModeManual mode
Page 25 and 26: TSTAT (Thermostat) ModeOperation 25
Page 27 and 28: Operation 27Start-Up Sequence (Igni
Page 29 and 30: Stove Maintenance ToolsMaintenance
Page 31 and 32: Maintenance 31b) Slide the the visu
Page 33 and 34: Maintenance 33Weekly Maintenance (o
Page 35 and 36: Maintenance 354. Remove the rear li
Page 37 and 38: Maintenance 37Yearly Maintenance (o
Page 43: Maintenance 43Wiring Diagram6 - Pin
Page 47 and 48: Optional Equipment 4713. Connect th
Page 49 and 50: Limited 7 Year Warranty 49To regist

AGP Pellet Stove - Avalon

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?