1535 Relative Humidity Transmitter - Novatech Controls

!SET-UP MODE SUMMARY4.1 SET-UP MODE FUNCTION'S1. Output Signal/Display Top Line2. Transmitter Zero Set3. Transmitter Full scale Set4. Drier Heating Type5. Reference gas Selection6. Combustion Oxygen %7. Ambient RH Sensor8. Temperature Units9. Drier Pressure Units10. Drier Pressure11. Purge/Cal Time12. Automatic Purge13. Time Between Purges14. Purge Duration15. Purge Freeze Time16. Number of Cal Gases17. Oxygen Content Cal Gas18. Maximum Acceptable Positive Error Cal Gas19. Maximum Acceptable Negative Error Cal Gas20. Period Between Gas Autocals21. Duration of Autocal22. Cal Gas Freeze Time23. Data to Print24. RS 232 Log25. Printer Baud Rate26. Damping FactorNote: If the Set-up menu does not match the functions in your instrument, check the software version number -On Page 2 of this manualOn the EPROM in the socket labelled IC3 (top left hand corner of the main PCB)4.2 SET-UP/MAINTENANCE/RUN SWITCHTo enter the ‘set-up’ mode via the keyboard, move the toggle switch to ‘SET-UP’. The outputs will be frozen whenin set-up mode.If purges or auto calibration occur while the mode switch is in ‘SET-UP’ mode, they will be delayed until the modeswitch is returned to ‘RUN’.To cancel a purge or calibration cycle, press ‘ENTER’ while in ‘RUN’ mode.4.3 FUNCTION SELECTWhen the SET-UP/MAINTENANCE/RUN switch is moved to ‘SET-UP’, the display will automatically read the lastset-up function selected.To select other function's, operate the ‘FUNCTION ⇑’ button to increment to the next function or ‘FUNCTION ⇓’ todecrement to the previous function.NOVATECH HUMIDITY TRANSMITTER Page 37