A R B O R Wood Stove - Avalon

More documents

Recommendations

Info

38 Listing LabelListing Label© Travis Industries 100-01190_000 4070808
39 Optional EquipmentRear Blower Installation (Part # 99000138)The rear blower improves heat transfer by pushing heated air through the convection channel. Operatinginstructions are described in the section "Blower Operation".1-1/2”aBend the legs of thethermodisk bracket tomake it 1-1/2” deep.bTuck the thermodisk into place. Itwedges between the rear heat sheildand the cast iron firebox.cRoute the wires on theoutside of the stove, behindthe convection jacket.dRoute the wires from the blower through the holein the back of the blower housing. Attach thesewires to the thermodisk wires.3/8" WrenchfAttach the blower to thestove with the three screwsincluded with the blower.ePosition the blower near the rear of the stove. Tuck all excess wire into theblower box, making sure it does not contact any moving parts. Make sure wheninstalling the blower, these wires do not become loose.gPlug the blower in. Do not route the power cord under or over the stove or in alocation where it may become damaged.© Travis Industries 100-01190_000 4070808
Page 1 and 2: \A r b o rWood StoveOwner's Manual
Page 3 and 4: Table of Contents 3General Informat
Page 5 and 6: Safety Precautions 5MobileHomeWhen
Page 7 and 8: Stove Installation (for qualified i
Page 15 and 16: Mobile Home RequirementsStove Insta
Page 19 and 20: Operating Your Appliance 19Safety N
Page 21 and 22: Bypass OperationOperating Your Appl
Page 23 and 24: Adjusting the Burn RateOperating Yo
Page 25 and 26: Operating Your Appliance 25Blower O
Page 27 and 28: Burn Procedure Pictorial OverviewOp
Page 29 and 30: TroubleshootingProblemSmoke Enters
Page 31 and 32: Maintaining Your Appliance 31Monthl
Page 33 and 34: Yearly Maintenance - ContinuedAdjus
Page 35 and 36: Maintaining Your Appliance 35Firebo
Page 37: Limited 5 Year Warranty 37CONDITION

A R B O R Wood Stove - Avalon

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?