download - Scotty Tele-Transport Corporation

More documents

Recommendations

Info

Setting Up the System Chapter 2The following settings should be made to the standard factory default setup:Setup AClkSel MASTERSynSel REDCommSel FDXDataMod BBDataLen SYNCH/STX Rate EXT DRCRX Rate EXT DRCTTY Mode AUTOI/Fctrl no selectionSetup BInvert no selectionTX Clock contTXC*RX Clock contRXCSyncOOS DisabledIdleSel DisabledAutoPhs OFFUpdateU EnabledClkLock DisabledSetup CRED I/F EIA-530BLK I/F EIA-530FIL I/F 102 / STDFILaddr 254RCUaddr 31Setup DMstrSlv SLAVEAlgrthm ALG 1This setup should then be permanently saved on the device.NOTES: Be sure the same key is used on the KIV-7HS units at both ends of thecommunication. Different versions of KIV-7HS might have compatibilityissues, they seem to synchronize but will not pass useful data. In this case, tryusing the same version of KIV-7HS at both ends, i.e., KIV-7HS to KIV-7HS orKIV-7HSB to KIV-7HSB.20 SCOTTY APL-B Users' Manual
Chapter 2Setting Up the System2.6.3 Default Setup and UsageThis setup is for outgoing and incoming video conferencing, including filetransfer and data sharing, at 64k and 128k over KIV #1.Setup:Connect “S0 I-Split” with “S0 Adtran”.Connect “Adtran Port 2” with “Bay 1-BLK” and “Bay 1-RED” with “<strong>Scotty</strong>Network” using two SCOTTY network plugs. The network plugs for bay 2 areunused and can remain in their positions.Insert a KIV-7 unit into bay 1.BAY 1-REDPCA/BDefault SetupAdtran and KIV-7 Configuration:All units remain in default setup (see previous chapters)SCOTTY APL-B Users' Manual 21
Page 3 and 4: Table of ContentsTable of Contents1
Page 5 and 6: Table of Contents4.4.9 Application
Page 7 and 8: Chapter 1Welcome1 Welcome1.1 Welcom
Page 9 and 10: Chapter 1Welcome1.3 The SCOTTY APL-
Page 11 and 12: Chapter 2Setting Up the System2 Set
Page 13 and 14: Chapter 2Setting Up the System2.1.3
Page 15 and 16: Chapter 2Setting Up the SystemThe
Page 17 and 18: Chapter 2Setting Up the SystemVideo
Page 19 and 20: Chapter 2Setting Up the System2.4 S
Page 23 and 24: Chapter 2Setting Up the System2.6 C
Page 25: Chapter 2Setting Up the System2.6.2
Page 29 and 30: Chapter 2Setting Up the SystemTo se
Page 33 and 34: Chapter 2Setting Up the SystemOpera
Page 36 and 37: Setting Up the System Chapter 22.6.
Page 42 and 43: Setting Up the System Chapter 22.9
Page 44 and 45: Setting Up the System Chapter 2In t
Page 46 and 47: Setting Up the System Chapter 240 S
Page 48 and 49: First Steps Chapter 33.3 The Main W
Page 50 and 51: First Steps Chapter 33.9 Transfer o
Page 52 and 53: First Steps Chapter 33.14 Controlli
Page 54 and 55: SCOTTY Details Chapter 44.2 The Mai
Page 56 and 57: SCOTTY Details Chapter 4The Far End
Page 58 and 59: SCOTTY Details Chapter 4Low Cost be
Page 60 and 61: SCOTTY Details Chapter 4If a Teleph
Page 62 and 63: SCOTTY Details Chapter 4Clear remov
Page 64 and 65: SCOTTY Details Chapter 44.4 The Vie
Page 66 and 67: SCOTTY Details Chapter 4Local left
Page 68 and 69: SCOTTY Details Chapter 4The availab
Page 70 and 71: SCOTTY Details Chapter 4Several app
Page 72 and 73: SCOTTY Details Chapter 4Status Bar
Page 74 and 75: SCOTTY Details Chapter 4A pulsing s
Page 76 and 77:
SCOTTY Details Chapter 4Default Int
Page 78 and 79:
SCOTTY Details Chapter 44.5.3 Video
Page 80 and 81:
SCOTTY Details Chapter 44.5.5 Direc
Page 82 and 83:
SCOTTY Details Chapter 44.5.7 File
Page 84 and 85:
SCOTTY Details Chapter 4• Use the
Page 86 and 87:
SCOTTY Details Chapter 4Additionall
Page 88 and 89:
SCOTTY Details Chapter 4Cancel clos
Page 90 and 91:
SCOTTY Details Chapter 44.7 Shortcu
Page 92 and 93:
SCOTTY Details Chapter 4Another con
Page 94 and 95:
SCOTTY Details Chapter 488 SCOTTY A
Page 96 and 97:
Data Package Chapter 55.2.2 During
Page 98 and 99:
Data Package Chapter 592 SCOTTY APL
Page 100 and 101:
Glossary Chapter 6FECCG.703G.711G.7
Page 102 and 103:
Glossary Chapter 6LANLESM4MPEGModem
Page 104 and 105:
Glossary Chapter 698 SCOTTY APL-B U
show all

download - Scotty Tele-Transport Corporation

Create successful ePaper yourself

Delete template?

Save as template?