download - Scotty Tele-Transport Corporation

Chapter 2Setting Up the SystemTo set the system back to outgoing 128k data rate operation, use the followingAdtran setup:• Enter the Config menu for dte #2• Set Bit Rate to 128000• Set Protocol to Bonding mode 12.6.4 I-Sync SetupWhen using one of the following setups, including the I-Sync adapter, theadapter needs to be configured once.For I-Sync configuration, connect “PC Com” with “I-Sync Config” and openthe Hyperterm “9600 Baud” shortcut. Enter the following sequence:• Press Enter to see the main menu• Choose Configuration (2) and press Enter• Choose Config Ports (2) and press Enter• Choose Port 1 (1) and press Enter. Choose X.21/C and press Enter.• Choose Port 2 (2) and press Enter. Choose X.21/C and press Enter.• Press ESC to get back into the Configuration menu• Choose Config Routing (2) and press Enter.• Choose Port 2, Port 1 (2) and press Enter.• Choose Save (7), press Enter and enter password (iboxx).2.6.5 Additional 64k ISDN DTE SetupThis setup extends the default setup, allowing outgoing and incoming VTC at64k and 128k over KIV #1, with a second path via KIV #2. This second pathallows outgoing Internet access, PC-fax, Magic Voice (ISDN or analog voiceand fax), etc. by using the KIV-7 DTE dial-through technology (requiring thatDTR is passed through the KIV-7 #2).Additional Setup:Connect “Adtran Port 1” with “Bay 2-BLK” and “Bay 2-RED” with “I_SyncPort 2”. Insert a KIV-7 unit into bay 2.Connect “S0 I-Sync” with the desired ISDN device(s):“A/B S0” for “Magic Voice” analog phone and fax.“S0 2” for Internet/Intranet access, PC-faxExternal ISDN equipmentSCOTTY APL-B Users' Manual 23