R TraceTek Leak Detection Product Selection Guide for Water

⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄RTT3000TraceTek Sensing Cable for Conductive LiquidsTraceTek TT3000 sensing cable detects thepresence of conductive liquids at any pointalong its length. Most acids and bases andeven deionized water can be sensed andlocated. Installed with a TraceTek alarm andlocating module, the cable senses the presenceof fluid, triggers an alarm, and pinpointsthe location.Distributed sensingTT3000 sensing cable provides distributedleak detection and location over awide range of areas. The cable is availablein a variety of lengths to provide asmuch coverage as needed.Design flexibilityTT3000 sensing cable is available withfactory-installed metal connectors thatplug together. The measurement circuit isnot dependent upon the conductivity ofthe leaking fluid. Therefore, the samecable will detect a wide range of fluidswithout special design considerations orcalibration.The cable is designed for a variety ofapplications, including floor surfaces, subfloors,equipment locations, pipes, storagetanks, and trenches. The cable issmall, lightweight, and flexible, allowingeasy installation. The smooth designallows quick drying.Advanced technologyRaychem’s conductive-polymer technologyand fluoropolymer construction makeTT3000 sensing cable mechanically strongand chemically resistant. The cable isconstructed of two sensing wires, an alarmsignal wire, and a continuity wire embeddedin a fluoropolymer carrier rod. This ruggedconstruction exposes no metal, and enablesthe cable to be reusable even in corrosiveenvironments.Ordering information⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄ ⁄⁄⁄⁄⁄⁄⁄⁄ ⁄ ⁄⁄ ⁄ ⁄ ⁄ ⁄ ⁄⁄ ⁄ ⁄ ⁄TT3000 zone sensing cable with factory-installed connector andend terminationCatalog numberTT3000–Zone–MCDescription5-ft (1.5 m) sensing cable withpreinstalled heat-shrink end termination⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄⁄⁄⁄⁄ ⁄⁄⁄ ⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄⁄ ⁄⁄ ⁄⁄ ⁄ ⁄⁄ ⁄ ⁄⁄ ⁄ ⁄ ⁄ ⁄ ⁄⁄ ⁄ ⁄ ⁄TT3000 modular sensing cables with factory-installed connectorsCatalog numberDescriptionTT3000–0.3M/1FT–MC1-ft (0.3 m) sensing cableTT3000–1M/3FT–MC3-ft (1 m) sensing cableTT3000–1.5M/5FT–MC5-ft (1.5 m) sensing cableTT3000–3M/10FT–MC10-ft (3 m) sensing cableTT3000–4.5M/15FT–MC15-ft (4.5 m) sensing cableTT3000–7.5M/25FT–MC25-ft (7.5 m) sensing cableTT3000–15M/50FT–MC50-ft (15 m) sensing cableTT3000–30M/100FT–MC100-ft (30 m) sensing cableTT3000 bulk sensing cable (connector kits required)for installation in double-containment piping⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄ ⁄Catalog numberTT3000–SCConnector kits (not shown)TT3000–CK–MC–M/FTT3000–CK–MC–MTT3000–CK–MC–FDescriptionBulk sensing cable on reel,Minimum length: 250 ft (75 m)Maximum length: 1000 ft (300 m)Components for five mated pairs ofconnectors (includes test tools)One pin-type connectorOne socket-type connector