TTS Golf RoToR oWNERS MANUAl - Hunter Industries

Next, insert the assembled tool, white lower snap ring and inlet valve into the rotor’s body cavity. To do so, it isnecessary to align the pointer arrow on the G800 Valve Tool with the alignment dot on the rotor’s flange. Thealignment dot is centered on the flange compartment lid adjacent to (next to) the body cavity opening (fig 107).A second alignment dot is located below the lid in case the flange compartment lid has been removed. Align thepointer arrow on the tool with the alignment dot and lower the assembled tool, white lower snap ring and inlet valveinto the rotor’s body.As the G800 Valve Tool is lowered into the rotor’s body, recessed areas on the black plastic part on the tool willengage vertical rails inside the body wall (fig 108). The tool must engage these rails or the inlet valve’s communicationport will not align with the communication port in the body cavity below. Continue pressing the assembled tool,white lower snap ring and inlet valve downward into the rotor’s body. Once the tool reaches the bottom, continuepressing firming to securely seat the inlet valve and snap ring.A distinct “click” sound should be heard as the snap ring is released and engages the snap ring groove in the rotor’sbody cavity. After the inlet and white lower snap ring have been properly seated, press down on the tool then rotatecounter-clockwise to disengage the tool’s metal hooks from the inlet valve. Next, raise the G800 Valve Tool out ofthe body. Finally, take whatever time is necessary to visually confirm that every part of the white lower snap ring issecurely seated into the snap ring groove.Fig 107 Fig 108Fig 106 Fig 107Fig 106 Fig 10735