School Bus Specifications - Texas Department of Public Safety

(3) REAR LIGHTS AND SIGNALS____Lights, backup1. Two (2) four (4) inch required (to meet FMVSS No. 108)____Lights, tail and stop1. Must be LED2. Two (2) required FMVSS 1083. Metal or durable plastic base4. Snap – on lens not acceptable5. Stop lamps to be thirty eight (38) square inches minimum, and mountednear belt line6. A set of four (4) inch minimum tail/stop lamps shall be installed belowthe thirty eight (38) square inch set____Lights, clearance and identification1. Must be LED2. Three (3) red on top close to vertical centerline3. Lamp centers spaced not less than six (6) or more than twelve (12)inches apart4. Activated by headlight switch5. Sealed type light6. Surface mounted with rust proof material guard unless recessed7. Use a universal type sealed electrical plug connector____Lights, alternately flashing signal1. Must be LED2. Two (2) red, two (2) amber (towards center)3. Amber manual, red automatic when door opens or stop signal arm isextended4. Lights shall be wired independently of ignition switch5. If master switch is on the W/C lift door shall activate the warning lightswhen open____Turn signal, hazard warning lamp1. Must be LED2. Meeting FMVSS 1083. Be amberC-8C-8C-8C-8C-9Section G-5