School Bus Specifications - Texas Department of Public Safety

(4) OTHER____Bumper, front1. Pressed steel channel or equivalent material (except Type A 19,500GVWR or less may have OEM supplied bumper2. At least three sixteenths (3/16) inch thick and not less than nine (9) andone half (1/2) inches wide (high)3. Black (Type A mfg standard color)4. Means provided to mount license plate for unobstructed view____Mirror system (all buses)1. Interior Mirrora. Six (6) inches by thirty (30) inchesb. Rounded cornerc. Protected edgesd. Type A buses shall be no smaller than fifty (50) square inches2. Rear Visiona. Must be adjusted by remote from the driver’s seatb. System consists of one flat and one convex lens per seatc. Mounted on a single breakaway arm with positive detent or lockd. Any fasteners shall be corrosion proofe. Type A buses may be exempt if no such cross/side brackets areavailable3. Cross/Side Viewa. One on each corner right and left frontb. Not reflect excessive glare from the headlights into driver’s eyesc. Any fasteners shall be corrosion proof____Steps, stirrup w/handle1. Installed on each front corner of body to facilitate cleaning of windshield2. On or in bumper for forward control buses3. Handle to be stainless steel, chrome plated, non-ferrous or equivalent4. Not required on Type A 14 - 30 passenger busesB-3C-10C-14Section G-6