SERVICE MANUAL SERIES 360 EP SERIES 360 ES - Precisa

Series 360 EP / ESIntroduction / Preparation of the tools3. Introduction / Preparation of the tools3.1 IntroductionIn the event of a broken flexure, it is recommended that all are replaced.page -----, repair set and page flexure sheetNB: SeeThe following assembly instructions provide information on how the flexures can be replaced most efficiently.It is important to employ a structured procedure for dismantling since it is essential to replacethe same parts (particularly screws) in the same place when re-assembling.The various items of the assembly instructions mean:(26/B3): component items -> 26 key no. to identify the component, B3 page of service manual[5]: tooling items see “Service tools and equipment” on page C23.2 Preparation of the toolsBefore dismantling the balance it is necessary to carry out some preparation of the tools.- Place the 2 long [2] and 2 short [3] support posts must be screwed into the correct places on the assemblyplate- The soldering iron should be plugged in or preheatedPrecisa Gravimetrics AG Index - C5