SERVICE MANUAL SERIES 360 EP SERIES 360 ES - Precisa

Series 360 EP / ESAssembling the weighing cell4. Pre-assemble the magnet cover with 2 screws → screws left and right5. Pre-assemble the transport safety device (6/A8) with the third screw (31/A8) and spring washer(37/A8) → gently tighten, use line-haed screwdriver6. Centring bush [16] shall be introduced between the balance arm-pilot and transportation safetydewice to assure constant annular grap. Tigten screw (31/A8) and remove centring bush.7.3 Assembling the sensor mechanism and the stopper1. Press the sensor mechanism carefully into the cutout in the chassis in the direction of the pot andsecure to the chassis with 3 screws (30/A8)2. Solder the two connection wires (3/A8) in parallel and strain-free to the sensor mechanism (24/A8)3. Turn back the stopper (2/A8) with brass screw (26/A8) by 90° and screw tight4. The stopper must be free of play and lie centrally in the symmetry screw (1/A8) → if necessary, readjustsymmetry screw7.4 Assembling new “V-flexure sheets“Abb. 410101. Select 2 new V-flexure sheets (7/A8) see “How to order spare parts / Anleitung zur Bestellung vonErsatzteilen” on page A22. Bring one „V-flexure sheet“ into position as in Fig. 4 → slots are on the support piece side (below)3. With a centring spigot [10], centre the „V-flexure sheet“ in the hole on the chassis side (above)4. With the second centring spigot [10], centre the „V-flexure sheet“ in the slot on the support pieceside (below)Precisa Gravimetrics AG Index - C12