Spaenaur

Inch
Pouces
Plastikit
«Plastikit»
Plastikit
«Plastikit»
O-Ring Seals
Joints toriques «O-Ring»
804-069 804-001
O-RING SEALS
of Nitrile
19 sizes — 78 pieces
from 1/8" to 3/4" I.D.
Priced Singly
Size: 4-1/2" x 2-3/4" x 1"
O-RING SEALS
of Viton
19 sizes — 78 pieces
from 1/8" to 3/4" I.D.
Recommended
O-RING Lubricants
(LUBRICANTS NOT SUPPLIED BY SPAENAUR)
Note: When installing O-Ring seals, it is important to lubricate the O-Ring and all the
metal parts which will be in contact with same.
*
May be used in systems having micronic filters.
† Will not pass through micronic filters.
J
CATALOG 13
LUBRICANT TEMPERATURE SEAL BEST USED WITH
RANGE
USE
Petroleum Base -20 to +180°F Assembly of Nitrile, Neoprene, Viton
Petrolatum * -29 to +82°C petroleum system
(may vary between sources) components i.e.fuel
and hydraulic
Barium grease -20 to +300°F Pneumatic (low Nitrile, Neoprene, Viton
Parker -29 to +149°C pressure-200 and most other petroleum oil
O-Lube † psi max) resistant rubbers
Silicone oil * -65 to +440°F Pneumatic- Some Nitrile, Neoprene,
(200,000 centi- -64 to +227°C High pressures Viton (will cause shrinkage
stokes only) and speeds of some compounds)
Cellulose ester -40 to +266°F Vacuum Static Silicone, Nitrile, Neoprene,
& castor oil -40 to +130°C 1 x 10 -7 Torr Viton, Butyl,
Celvacene
Ethylene-Propylene
Silicone Grease -100 to +400°F Pneumatic Nitrile, Neoprene,Viton
Versilube -73 to +204°C 3000 psi and (will shrink some compounds
high speed
and will dissolve
some silicone rubber)
Silicone Grease -65 to +400°F Vacuum, EXTREME Nitrile, Butyl, Ethylene,
DC55 -54 to +204°C TEMPERATURE Lub. Propylene,Viton, Neoprene
(MIL-G- 4343)
Apiezon N +60 to +85°F Vacuum Nitrile, Butyl, Ethylene
Made in England +15 to +30°C 1 x 10 -8 Propylene, Viton, Neoprene
Skydrol -65 to +200°F Assembly phospate Butyl, Ethylene,
Base Grease -64 to +93°C ester systems Propylene
Allube
See section 'R' for
Compound Selection Guide
Tel: 1-800-265-8772 Fax: 519-744-0818
J97
25 Apr 02