Spaenaur

Inch
Pouce
304 STAINLESS STEEL EYE BOLTS, Forged
A B C D E Approx. Rated Unit
SPAENAUR No. Thread Size Length Eye Overall Lbs. per Capacity Pkg.
PLAIN TYPE UNC-2A of Shank I.D. O.D. Length 100 Pcs. Lbs. Qty.
024-890 1"-8 2-1/2" 1-13/16" 3-9/16" 6-3/16" 226.0 9370 1
Plain Type
E
Eye Bolts
Boulons à oeil
D
C
B
(without nut)
B
A
316 STAINLESS FORGED EYE BOLTS
Drop Forged - Plain Finish
Shoulder Type
Maximum load rating for eyebolts are based on a straight vertical lift (x) in a
gradually increasing manner. Angular lifts will significantly lower maximum loads
and should be avoided whenever possible. If an angular lift is required (y), a
properly seated Shoulder eyebolt must be used. Loads should always be applied
to eyebolts in the plane of the eye, not at some angle to this plane. Angular lifts
must never be more than a 45° pull.
Vertical loads are based on safety factor of 5 to 1.
Overall Max. Safe Unit
SPAENAUR Thread Size Length Eye Length Working Pkg.
No. UNC of Shank I.D. O.D. Min./Max. Load Lbs. Qty.
024-832 1/4"-20 1" 3/4" 1-1/4" 2-7/32/2-17/32" 500 1
024-833 5/16"-18 1-1/8" 7/8" 1-1/2" 2-21/32/2-31/32" 900 1
024-834 3/8"-16 1-1/4" 1" 1-21/32" 3-3/32/3-15/32" 1400 1
024-835 1/2"-13 1-1/2" 1-3/16" 2-1/16" 3-13/16/4-3/16" 2600 1
024-836 5/8"-11 1-3/4" 1-3/8" 2-1/2" 4-9/16/4-15/16" 4000 1
024-837 3/4"-10 2" 1-1/2" 2-13/16" 5/5-1/2" 6000 1
Angular lifts should be avoided whenever possible.
Note:
All Eye Bolts and Eye Nuts, whether in blanks or fully machined, as shown on pages B318 to B320, are covered by our
standard warranty. The warranty becomes VOID whenever modifications are made or further machining is done by the
buyer, also in cases where these items are subject to an angular lift or pull.
CATALOG 13
Quality fasteners -
inspected, tested and certified!
Tel: 1-800-265-8772 Fax: 519-744-0818
B319
14 Sept 01