TT-3020B Installation Manual - Polaris-as.dk
TT-3020B Installation Manual - Polaris-as.dk
TT-3020B Installation Manual - Polaris-as.dk
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Thrane & Thrane<br />
<strong>TT</strong>-<strong>3020B</strong><br />
Capsat Transceiver<br />
<strong>Installation</strong> <strong>Manual</strong><br />
2.5 <strong>TT</strong>-<strong>3020B</strong> Capsat Transceiver<br />
2.5.1 Mounting bracket<br />
Figure 4: <strong>TT</strong>-<strong>3020B</strong> Capsat Transceiver<br />
The <strong>TT</strong>-<strong>3020B</strong> Capsat Transceiver is supplied with an universal mounting bracket (41-<br />
100562) which allows "over" or "under" mounting to e.g. a table or ceiling.<br />
It is recommended that the Transceiver is mounted in an open air location allowing the<br />
operator full access to the front panel in a distress situation.<br />
When the Transceiver is used with other Thrane & Thrane equipment such <strong>as</strong> the<br />
<strong>TT</strong>-3606A Message Terminal or the <strong>TT</strong>-3210A Radiotelex Modem, stacked mounting may<br />
be achieved using mounting bracket 41-100742.<br />
It is strongly recommended not to stack mount the <strong>TT</strong>-<strong>3020B</strong> Capsat Transceiver with<br />
the <strong>TT</strong>-3680A Power Supply because of the heat generation from this unit.<br />
2.5.2 Communication port<br />
The <strong>TT</strong>-<strong>3020B</strong> Capsat Transceiver communicates with a controller device via the<br />
standard EIA RS-232D ports, located on the rear panel at X4.<br />
2.5.2.1 Baudrate and protocol settings<br />
The <strong>TT</strong>-<strong>3020B</strong> accepts the following:<br />
Page 16 30MAY95
Change language