TT-3020B Installation Manual - Polaris-as.dk
TT-3020B Installation Manual - Polaris-as.dk
TT-3020B Installation Manual - Polaris-as.dk
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Thrane & Thrane<br />
<strong>TT</strong>-<strong>3020B</strong><br />
Capsat Transceiver<br />
<strong>Installation</strong> <strong>Manual</strong><br />
3.4.1 Entering your mobile type and number<br />
For e<strong>as</strong>e of operation and general information when you operate your Capsat system,<br />
you should consider to enter the mobile number.<br />
Just type in the Inmarsat-C 9 digit number that you have received from your P<strong>TT</strong><br />
authorities.<br />
An Inmarsat-C mobile number is always in the range:<br />
400000000 to 499999999<br />
If you type a number outside this range the Transceiver will ignore it.<br />
You should not attempt to use your equipment before you have received a mobile<br />
number, because the Mobile Number means that you have been registred in the<br />
datab<strong>as</strong>e for the Inmarsat-C Network.<br />
The Transceiver only uses the mobile number when sending Message Position Reports<br />
(see the Message Handling Software Operators Guide), to indicate which Transceiver<br />
originated the position message.<br />
3.4.1.1 F<strong>as</strong>t access to the Mobile Type<br />
You can get an e<strong>as</strong>y first time installation, <strong>as</strong> the Transceiver will automatically<br />
recognize if the mobile number h<strong>as</strong> never been entered before, and automatically bring<br />
you to the Change Mobile Type menu.<br />
In this situation the Mobile Number will display <strong>as</strong><br />
Mobile number : (unknown)<br />
You can only change the Mobile Type the first time you enter the System Generation<br />
and the status of the Mobile Type reads (unknown). If you see a Mobile Number here,<br />
then you may skip this step <strong>as</strong> it h<strong>as</strong> been performed by your dealer.<br />
The procedure of changing the Transceiver to Maritime is shown below:<br />
Page 38 30MAY95