TT-3020B Installation Manual - Polaris-as.dk

More documents

Recommendations

Info

Thrane & Thrane TT-3020B Capsat Transceiver Installation Manual 2.9 TT-3042B Remote Alarm The TT-3042B Remote Alarm is connected to the TT-3020B by means of the Transceivers X5 T-Bus connector. Please refer to section 2.5.3. Figure 13: Remote Alarm with printer. The TT-3042B Remote Alarm is intended for GMDSS installations. The TT-3042B can all the same be used to print out SafetyNet EGC messages, via the built-in thermal printer and indicate reception of EGC messages in general. The TT-3020B Transceiver can accomodate up to 8 Remote Alarms at the same time, but each alarm must have it's own unique T-Bus address in the range 0-7. If more than one TT-3042B Remote Alarm is connected, the printer of the Remote Alarm with the lowest address (first in the list of Remote Alarms seen with the ru -l command) will be used as the default printer, whereas the other printers will be back-up printers in case the first printer runs out of paper or has a malfunction. If you do not connect a printer at the Transceiver, it will use the Remote Alarm printer instead, but it is also possible to configure the Transceiver to use the Remote Alarm printer always even if a Transceiver printer is available. Further you can select different types of messages to go to either (or both) of the two printer types. The Remote Alarm address is selected with a DIP Switch array inside Paper Bay of the TT-3042B. Please refer to the TT-3042B Remote Alarm Reference Manual for detailed information. The address selected for a Remote Alarm must not conflict with any other Remote Alarm connected to the same TT-3020B Capsat Transceiver. If you enter the Capsat Program's Terminal mode and type the command ru -l you will see a list of the currently attached remote units and their addresses. In this way you will be able to select unique addresses for all devices to be connected. 2.10 Built-in GPS (optional) GPS means Global Positioning System. Page 32 30MAY95
Thrane & Thrane TT-3020B Capsat Transceiver Installation Manual The GPS module is installed from the factory and you need not perform any installtion to use it. If you have ordered your Capsat Transceiver without a built-in GPS and you later need to install a GPS module, then you should contact your dealer to obtain the Technical Reference Manual for instuctions on how to accomplish this. 30MAY95 Page 33
Page 1 and 2: TT-3020B Maritime Capsat Transceive
Page 3: Safety Summary The following genera
Page 6 and 7: Thrane & Thrane TT-3020B Capsat Tra

TT-3020B Installation Manual - Polaris-as.dk

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?