03.01.2013 Views

THE OCULUS-F/64 FRAME GRABBER User's Manual

THE OCULUS-F/64 FRAME GRABBER User's Manual

THE OCULUS-F/64 FRAME GRABBER User's Manual

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

2.2 <strong>OCULUS</strong>-F/<strong>64</strong> INSTALLATION<br />

SETTING <strong>THE</strong> BASE ADDRESS DIP SWITCH<br />

The SW1 DIP switch is used to set the I/O base address of the Oculus-F/<strong>64</strong><br />

board. The factory default Base Address is 280h. The location of SW1 on the<br />

board and diagrams for various address selections, are found in Appendix B of<br />

this manual.<br />

Typically there is no address conflict requiring a change in I/O address. But if<br />

there is, the new address chosen must differ from the addresses of other boards<br />

residing in the computer. Both the DOS and Windows configuration programs<br />

have a configuration item for selecting the new I/O address and both programs<br />

will display a pictorial of the required switch positions.<br />

Caution: Do not use a pencil to set the miniature switches, because the<br />

graphite residue can cause damage to the switches.<br />

O<strong>THE</strong>R SWITCHES AND JUMPERS<br />

In all normal situations, there is no need to change other configuration switches<br />

and jumpers from their factory default. Appendix B details what these defaults<br />

are and when they may need changing.<br />

INSTALLING <strong>THE</strong> <strong>OCULUS</strong>-F/<strong>64</strong> INTO <strong>THE</strong> PC<br />

To install the Oculus-F/<strong>64</strong> into a PC use the following procedure. Please<br />

ensure that you have discharged any static electricity by grounding yourself to<br />

the chassis of the PC before you begin.<br />

• Turn off your computer, but keep it connected to the AC power source.<br />

This maintains a ground connection to the computer chassis. Remove the<br />

cover.<br />

• Choose an available 16-bit full length expansion slot. (Two slots are<br />

required for Oculus-F/<strong>64</strong>'s with camera adapter modules).<br />

• Install the Oculus-F/<strong>64</strong> and secure the bracket with the fastening screw.<br />

This provides a solid electrical ground to prevent damage from static<br />

discharge when connecting or disconnecting cameras and monitors.<br />

• Connect camera and display monitor as described in the following<br />

sections. The suggested power on sequence is display monitor, computer,<br />

and camera.<br />

Page 2-4 The <strong>OCULUS</strong>-F/<strong>64</strong> <strong>User's</strong> <strong>Manual</strong>

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!