Manual MR3140-M - DResearch
Manual MR3140-M - DResearch
Manual MR3140-M - DResearch
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>DResearch</strong> – User <strong>Manual</strong> TeleObserver <strong>MR3140</strong>-M 2011-02-03<br />
2.3 Significance of the status LEDs<br />
On the front of the unit there are four coloured LEDs which indicate the current status of the device.<br />
At any time you can determine the current status of the device from the colour codes. We recommend<br />
that you print out the following table and keep it with your service documents.<br />
LED State Description<br />
Status<br />
(state of the device)<br />
HD<br />
(recording)<br />
Link<br />
(LAN-connection)<br />
Archive<br />
(archive fill level)<br />
off � device is switched off<br />
green � device is ready for operation<br />
orange � device is booting or shutting down<br />
red � Error – contact the service department!<br />
off � device is not recording<br />
green � actively recording into the ring archive (normal)<br />
orange � actively recording into the alarm archive (alarm event)<br />
orange<br />
flashing<br />
� HD will be deleted and adopted by the device in 30 seconds<br />
red � hard disk is not available or could not be recognised/adopted by the<br />
device<br />
� no recording on the hard disk<br />
� other errors<br />
off � no connection between PC and device<br />
green � active data transmission, connection between PC and device<br />
orange � not busy<br />
red � Error – no communication<br />
off � archives cannot be recognised (fault)<br />
green � 0% - 60% of the capacity full<br />
orange � > 60% - 80% of the capacity full<br />
red � > 80% - 100% of the capacity full<br />
The codes listed here could be changed by the manufacturer. If in doubt contact your system<br />
integrator or the manufacturer.<br />
17